Configuration Setup
RF Mode
In the RF Mode the Wireless Remote Control makes it possible to perform an RF communication with the projector through the Wireless base.
This is only possible with the Wireless Rugged Remote Control ('General lnformation' page 8) .
How to connect
The connection between the Wireless base and the projector uses a standard serial cable.
The Wireless Rugged Remote can communicate with one or more projectors, this can be done in two ways:
-One Remote communicates with different projectors each of them using a base (image 1)
-The Remote communicates with different projectors connected in a loop through configuration, this configurarion uses one base (image 2).
The RF link runs at a fixed baudrate of 57600.
The supply of the base is done through its,156'COMM3&0257PORT' using a standard serial cable. 56,12873&0257
image 1 | image 2 |
COMM PORT RS 232/422
22