Menu Setup
RF Options: Synchronize base
The wireless base and the remote have to be synchronized (same RF address and freq. band ) To synchronize the base follow next procedure:
1. | Connect the 'COMM PORT' of the base to the 'COMM PORT' of the projector using a standard | |
| cable (image 1) |
|
2. | Browse with + when in the 'RF Options Menu' | |
3. Select 'Synchronize base' | (Menu 1) | |
4. Press < ENTER>, the remote displays following message (menu 2) | ||
5. | Connect the RS232 port of the wireless base to the RS232 port of the remote using a standard | |
| &0 |
|
| 3257 |
|
| serial cable (image 1) |
|
6. Press < ENTER>, the remote displays following message during a few seconds (menu 3) | ||
7. | Depending on whether the operation succeeded or not one of following messages may be | |
| displayed (menu 4,5) | &200325756 |
8. | Exit the menu with <EXIT> | |
NO COMMUNICATION | NO UPDATE |
RF OPTIONS | CONNECT REMOTE TO BASE |
SYNCHRONIZE BASE | AND PRESS <ENTER> |
Menu 1 | Menu 2 |
NO UPDATE | NO UPDATE |
SYNCHRONIZING BASE | SYNCHRONIZATION FAILED |
| PRESS <ENTER> TO RETRY |
Menu 3 | Menu 4 |
NO UPDATE |
|
BASE SYNCHRONISED |
|
PRESS <EXIT> TO CONTINUE |
|
Menu 5 |
|
30