Barco R9840170, R9840171, R9840176 manual Additionnal Information, Messages

Page 34

Additionnal Information

Additionnal Information

Messages

MESSAGES	POSSIBLE CAUSES	TO CHECK

NO COMMUNICATION	-hardware	-connections
	-parameter mismatch	-address match proj/RRC
		-baudrate match proj/RRC
NO DISPLAY DATA AVAILABLE	-No display on projector	-
	(6*00 series projectors)	-
	(6*00 series projectors)
RF=LOW	-parameter mismatch	-RF addr match proj/RRC
	-no supply	-Freq band match proj/RRC
		perform synchronization if
		necessary (page 30 )
		-connection (com port)
NO UPDATE	during synchronisation	-
	update (polling) is inter-	-
	update (polling) is inter-
	rupted

34

Image 34

Contents Rugged Remote Control for ELM/SLM Projectors R9840170 R9840171 R9840176Page Contents Installation Instructions Safety InstructionsSafety Instructions Owners RecordOn Safety Safety Warning100-240VAC 0.4A 47-63 Hz Safety indication on the product On installationOn servicing On repacking On cleaningDefinition Accessories Rugged Remote ControlUpgrade Kits General InformationContents Specifications DescriptionDescription & Specififcations Charger Serial interface RS 232/422Description & Specififcations Keypad Exit EnterDescription & Specififcations Wireless Base Installation Setup Installation setupPower Connections Installation Setup Power on switch Supplying the Wireless BaseInstallation Setup Charging the batteries No Communication ADDR=1 BAT=LOW Press Adjust to EnterNo Update Press ANY KEY to ExitInstallation Setup Changing the batteries Configuration Setup Configuration SetupRemote Mode Configuration Setup Lamp Read Mode Configuration Setup RS232/422 Communication ASLQ*1DVVDGDSWHU*1$Configuration Setup Configuration Setup RF Mode Download is performed through the RS232 communication port No Communication ADDR=1Installation Settings Identification menu Communication Menu COMM.PORT Auto Baudrate XLR No Communication COM.PORT Auto BaudratePress Enter No Communication Setting UP Communication RF OptionsPress Enter to browse No Update Base Synchronised Press Exit to Continue Select Synchronize baseInstallation settings menu How to change the address Select Change addressNo Communication Change Address BAT=ACT Press Adjust to Enter Operation Mode OPER. Mode Remote OPER. Mode Lamp ReadNo Communication Lamp Select Operation Mode by pressing Enter No Communication Operation Mode OPER. Mode RemoteMenu Setup Remote Mode Menu Communication COM.PORT XLRAdditionnal Information Additionnal InformationMessages Mechanical Information DimensionsMechanical Information Mechanical Information Barco NV / Projection Systems