CHAPTER 3 CONTROL PANEL
Reset/Hex Dump Mode
The printer has a reset/hex dump mode where you can select and perform any of three resets or a hex dump print. Follow these steps:
1.Press the SELECT switch to turn the printer
2.Hold down the SELECT switch and press the FF/CONT switch.
The printer enters the reset/hex dump mode. The ALARM lamp blinks to indicate that the first choice, User Reset 1, is selected. See the table below.
3.Press the FF/CONT switch to select another choice.
Every time you press the switch, the blinking lamp changes to select a choice. See the table below.
4.Press the SELECT switch to perform the selected choice.
Blinking Lamp | Choice |
ALARM | User Reset 1 |
READY | User Reset 2 |
DATA | Factory Reset |
MANUAL | Hex Dump Print |
Function
The printer is restored to the user default settings without clearing permanent fonts and macros. You can execute this by
The printer is restored to the user default settings and permanent fonts and macros are cleared.
The printer is restored to the factory settings and permanent fonts and macros are cleared.
The printer can print data as hexadecimal values, so that you can check data errors and problems. To exit from this mode, you have to reset the printer.
After resetting, the printer returns to the ready status.
✒Note
User settings are the printer settings that you change with the remote printer console program. See the software setup guide for details.