USER’S GUIDE
For errors shown below, the printer indicates an operator call by blinking the ALARM lamp and printing the error messages on paper.
Error
Memory Full
Print Overrun
Centronics
Interface Line
Error
Serial Interface Framing Error
Serial Interface Parity Error
Serial Interface Overrun Error
Action
∙Press the FF/CONT switch to print the data remaining in the printer.
∙If you are using the supplied Windows driver, try again after setting the TrueType mode to “Print as Graphics” in the PRINT menu of your application software.
∙Expand the printer memory with the optional memory board.
∙Reduce the print resolution or reduce the complexity of your document.
∙Press the FF/CONT switch to print the data remaining in the printer.
∙If you use the supplied Windows driver, try again after setting the TrueType mode to ‘Print as Graphics’ in the PRINT menu of your application software.
∙If this does not clear the error, reduce the complexity of your document or reduce the print resolution.
∙Press the FF/CONT switch to resume printing.
∙Check that the connection between your computer and printer is secure and correct, and check the interface cable.
∙Press the FF/CONT switch to resume printing.
∙Check the communication parameters settings such as baud rate and stop bit on both your computer and printer.
∙Press the FF/CONT switch to resume printing.
∙Check the communication parameters settings such as bit length and parity on both your computer and printer.
∙Press the FF/CONT switch to resume printing.
∙The interface hardware may be damaged, consult your dealer.