USER’S GUIDE
Questions
I cannot print from my application software.
How can I change the printer’s default settings?
Sometimes I get a Print Overrun error when printing certain documents from Windows.
Sometimes I get the Memory Full message. How can I correct this?
Recommendation
∙If you are using Windows 3.1, make sure the supplied printer driver is installed and selected with your application software.
∙If you are using Windows 3.0 or earlier, make sure that proper printer driver is installed and selected to match the printer emulation.
∙If you use the serial interface, make sure that the serial slide switch of the serial interface is in the correct position and the interface settings are correctly set up with the DIP switches.
Exit to DOS and use the remote printer console program.
∙Set the TrueType mode to ‘Print as graphics’ from the PRINT menu in your application software.
∙Reduce the print resolution or reduce the complexity of your document and try again.
∙Set the TrueType mode to ‘Print as graphics’ from the PRINT menu in your application software.
∙Another solution is to purchase more memory.
∙Reduce the print resolution or reduce the complexity of your document and try again.
Setting up the Printer for Apple Macintosh Computers
Questions
The printer does not print.
Recommendation
Check the following:
∙The printer is plugged in.
∙Paper is loaded.
∙No error conditions are active (any blinking lamps on printer.)
∙Printer is