Muratec MFX-2500 How to set the document, Acceptable document size, Auto document size detection

Getting started

How to set the document

Acceptable document size

The acceptable dimensions as follows:

Automatic document feeder (ADF) (width ⋅ length)

	SINGLE-SHEET		MULTIPLE-SHEET
Maximum:	300	⋅ 900 mm (Tx)	297 ⋅ 420 mm
	300	⋅ 450 mm (Copy)
Minimum:	120	⋅ 100 mm	148 ⋅ 105 mm
Weight:	30.2 – 104.7 g/m2		52.3 – 104.7 g/m2

You can set up to about 50 sheets of A4, 40 sheets of B4 or 30 sheets of A3 sized document in the ADF at a time.

Flatbed scanner (FBS) glass (width ⋅ length)

Maximum: 297 ⋅ 420 mm

Things not to put in your machine

To avoid paper jams and damage to your machine, don’t insert:

•Folded, curled, torn, wrinkled or very thin pages

•Documents with staples, glue, tape, paper clips or still-wet correction fluid

•“Sticky notes” (or documents with “sticky notes” attached)

•Cardboard, newspaper or fabric

•Pages with duplicating carbon on either side

•Credit cards or any small, thick items

How to set the document

When set the documents in the Automatic Document Feeder

1	Set your document face up into the docu-
	ment feeder. The document should be
	aligned to the rear left corner.
2	Adjust the document guide to fit your docu-
	ments.

Note: You cannot set the different sized docu- ment at a time.

When set the documents on the FBS glass

1 Lift the platen cover fully.

2 Set your document face down on the FBS glass. The document should be aligned to the rear left corner.

3 Gently close the platen cover.

Note: If you do not lift the platen cover fully, the document size will not be detected automatically.

Auto document size detection

The following sized documents are automatically detected.

•A3 (297 ⋅ 420 mm)

•B4 (257 ⋅ 364 mm)

•A4 (210 ⋅ 297 mm)

•B5 (182 ⋅ 257 mm)

•A5 (148 ⋅ 210 mm)

1.18