Linksys PAP2-VU Placement Options, Stand Option, Phone Adapter’s Interactive Voice Response Menu

Page 12

Phone Adapter with 2 Ports for Voice-over-IP

Placement Options

There are three ways to place the Phone Adapter. The first way is to place the Phone Adapter horizontally on a surface. The second way is to stand the Phone Adapter vertically on a surface. The third way is to mount the Phone Adapter on a wall. The second and third options are explained in further detail below.

Stand Option

1.Remove the plate from the Phone Adapter’s bottom panel.

2.Line up the pegs of the Phone Adapter’s base with the mounting holes of the Phone Adapter’s bottom panel.

3.Insert the Phone Adapter’s base into the Phone Adapter’s bottom panel. Push the base in until it fits snugly.

4.Place the Phone Adapter in an appropriate location.

Congratulations! The installation of the Phone Adapter is complete.

If you need to change any of the Phone Adapter’s network settings, proceed to “Chapter 4: Using the

Phone Adapter’s Interactive Voice Response Menu.”

Figure 3-5: Attaching the Phone

Adapter’s Base

Figure 3-6: Phone Adapter Standing

on Base

Chapter 3: Connecting the Phone Adapter

7

Placement Options

Image 12

Contents Phone Adapter Division of Cisco Systems, IncPage How to Use this Guide Copyright and TrademarksTable of Contents Back Panel Front PanelIntroduction WelcomeWhat’s in this Guide? What’s in this Guide? Getting to Know the Phone Adapter Back Panel PortsFront Panel Phone Adapter’s LEDs are located on the front panelPhone is being used or an incoming call has been detected Connecting the Phone Adapter Instructions for Connecting the Phone AdapterOverview InternetConnect the Telephone Cable Placement Options Stand OptionRemove the plate from the Phone Adapter’s bottom panel Phone Adapter’s Interactive Voice Response MenuWall-Mount Option Measurement between Wall-Mount SlotsUsing the Phone Adapter’s Interactive Voice Response Menu Accessing the Interactive Voice Response MenuUsing the Interactive Voice Response Menu Use this command to enter Response Menu Interactive Voice Response MenuNot press any other keys until you Key or hang up to exitHas been enabled or disabled. If 101 Enter 1 to enableEnter 0 to disable Check Dhcp 100Address using Static IP address When entering a Decimal pointSubnet Mask Mask using Network mask When entering a Decimal pointAddress Address using Static gateway IP address When entering a Decimal pointPhone Adapter Manual Reboot 732668 131 Enter the IPConfiguring the Settings for Your Internet Phone Service Appendix a Troubleshooting Common Problems and SolutionsAppendix a Troubleshooting Application Start and End Protocol IP Address Enable Internet phone 5060 toIP address Phone Adapter Internet phone 53 to IP address Phone Adapter Internet phone 69 toPhone Adapter with 2 Ports for Voice-over-IP Application Start and End Protocol IP Address Enable Phone Adapter with 2 Ports for Voice-over-IP Phone Adapter with 2 Ports for Voice-over-IP Application Start and End Protocol IP Address Enable Frequently Asked Questions Pick up the phone and dial as you normally wouldCan I make calls while I’m browsing the Internet? Appendix B Windows Help Shared ResourcesNetwork Neighborhood/My Network Places Appendix B Windows Help Appendix C Glossary Appendix C Glossary Phone Adapter with 2 Ports for Voice-over-IP Phone Adapter with 2 Ports for Voice-over-IP Phone Adapter with 2 Ports for Voice-over-IP Phone Adapter with 2 Ports for Voice-over-IP Appendix D Specifications Dimensions Storage HumidityMm x 101 mm x 15 mm Appendix E Warranty Information Limited WarrantyAppendix E Warranty Information Appendix F Regulatory Information FCC StatementAppendix F Regulatory Information Appendix G Contact Information Appendix G Contact Information