Linksys PAP2-VU manual Interactive Voice Response Menu, Use this command to enter Response Menu

Page 15

Phone Adapter with 2 Ports for Voice-over-IP

After entering a value, such as an IP address, press the # (hash) key to indicate you have finished your selection. To save the new setting, press 1. To review the new setting, press 2. To re-enter the new setting, press 3. To cancel your entry and return to the main menu, press * (star).

For example, to enter the IP address 191.168.1.105 by keypad, press these keys: 191*168*1*105. Press the # (hash) key to indicate that you have finished entering the IP address, and then press 1 to save the IP address. To cancel your entry and return to the main menu, press * (star).

If the menu is inactive for more than one minute, the Phone Adapter will time out. You will need to re-enter the menu by pressing ****.

The settings you have saved will take effect after you have hung up the telephone. The Phone Adapter may reboot at this time.

Interactive Voice Response Menu

Action	Command	Choices	Description
	(press these
	keys on the
	telephone)

Enter Interactive Voice	****		Use this command to enter the
Response Menu			Interactive Voice Response Menu. Do
			not press any other keys until you
			hear, “Configuration menu. Please
			enter option followed by the # (hash)
			key or hang up to exit.”

10			Chapter 4: Using the Phone Adapter’s Interactive Voice Response Menu
				Using the Interactive Voice Response Menu

Image 15

Contents Division of Cisco Systems, Inc Phone AdapterPage Copyright and Trademarks How to Use this GuideTable of Contents Front Panel Back PanelIntroduction WelcomeWhat’s in this Guide? What’s in this Guide? Back Panel Ports Getting to Know the Phone AdapterFront Panel Phone Adapter’s LEDs are located on the front panelPhone is being used or an incoming call has been detected Internet Connecting the Phone AdapterInstructions for Connecting the Phone Adapter OverviewConnect the Telephone Cable Phone Adapter’s Interactive Voice Response Menu Placement OptionsStand Option Remove the plate from the Phone Adapter’s bottom panelMeasurement between Wall-Mount Slots Wall-Mount OptionUsing the Phone Adapter’s Interactive Voice Response Menu Accessing the Interactive Voice Response MenuUsing the Interactive Voice Response Menu Key or hang up to exit Use this command to enter Response MenuInteractive Voice Response Menu Not press any other keys until youCheck Dhcp 100 Has been enabled or disabled. If101 Enter 1 to enable Enter 0 to disableNetwork mask When entering a Decimal point Address usingStatic IP address When entering a Decimal point Subnet Mask Mask using131 Enter the IP Address Address usingStatic gateway IP address When entering a Decimal point Phone Adapter Manual Reboot 732668Configuring the Settings for Your Internet Phone Service Common Problems and Solutions Appendix a TroubleshootingAppendix a Troubleshooting IP address Phone Adapter Internet phone 69 to Application Start and End Protocol IP Address EnableInternet phone 5060 to IP address Phone Adapter Internet phone 53 toPhone Adapter with 2 Ports for Voice-over-IP Application Start and End Protocol IP Address Enable Phone Adapter with 2 Ports for Voice-over-IP Phone Adapter with 2 Ports for Voice-over-IP Application Start and End Protocol IP Address Enable Pick up the phone and dial as you normally would Frequently Asked QuestionsCan I make calls while I’m browsing the Internet? Appendix B Windows Help Shared ResourcesNetwork Neighborhood/My Network Places Appendix B Windows Help Appendix C Glossary Appendix C Glossary Phone Adapter with 2 Ports for Voice-over-IP Phone Adapter with 2 Ports for Voice-over-IP Phone Adapter with 2 Ports for Voice-over-IP Phone Adapter with 2 Ports for Voice-over-IP Appendix D Specifications Dimensions Storage HumidityMm x 101 mm x 15 mm Limited Warranty Appendix E Warranty InformationAppendix E Warranty Information FCC Statement Appendix F Regulatory InformationAppendix F Regulatory Information Appendix G Contact Information Appendix G Contact Information