Linksys PAP2-VU manual Check Dhcp 100, Has been enabled or disabled. If, Use a static IP address

Page 16

Phone Adapter with 2 Ports for Voice-over-IP

Interactive Voice Response Menu

Action

Command

Choices

Description

 

(press these

 

 

 

keys on the

 

 

 

telephone)

 

 

 

 

 

 

Check DHCP

100

 

Use this command to find out if DHCP

 

 

 

has been enabled or disabled. If

 

 

 

enabled, the Phone Adapter will be

 

 

 

automatically assigned an IP address

 

 

 

by your network router or gateway. If

 

 

 

disabled, then the Phone Adapter will

 

 

 

use a static IP address.

 

 

 

 

Enable/Disable DHCP

101

Enter 1 to enable

Enable or disable the Phone Adapter’s

 

 

Enter 0 to disable

DHCP feature. If your network router

 

 

 

or gateway assigns IP addresses, then

 

 

 

enter 1. Otherwise, enter 0.

 

 

 

 

Check IP Address

110

 

You will hear the current IP address of

 

 

 

the Phone Adapter.

 

 

 

 

Chapter 4: Using the Phone Adapter’s Interactive Voice Response Menu

11

Using the Interactive Voice Response Menu

Image 16
Contents Phone Adapter Division of Cisco Systems, IncPage How to Use this Guide Copyright and TrademarksTable of Contents Back Panel Front PanelWelcome IntroductionWhat’s in this Guide? What’s in this Guide? Getting to Know the Phone Adapter Back Panel PortsPhone Adapter’s LEDs are located on the front panel Front PanelPhone is being used or an incoming call has been detected Connecting the Phone Adapter Instructions for Connecting the Phone AdapterOverview InternetConnect the Telephone Cable Placement Options Stand OptionRemove the plate from the Phone Adapter’s bottom panel Phone Adapter’s Interactive Voice Response MenuWall-Mount Option Measurement between Wall-Mount SlotsAccessing the Interactive Voice Response Menu Using the Phone Adapter’s Interactive Voice Response MenuUsing the Interactive Voice Response Menu Use this command to enter Response Menu Interactive Voice Response MenuNot press any other keys until you Key or hang up to exitHas been enabled or disabled. If 101 Enter 1 to enableEnter 0 to disable Check Dhcp 100Address using Static IP address When entering a Decimal pointSubnet Mask Mask using Network mask When entering a Decimal pointAddress Address using Static gateway IP address When entering a Decimal pointPhone Adapter Manual Reboot 732668 131 Enter the IPConfiguring the Settings for Your Internet Phone Service Appendix a Troubleshooting Common Problems and SolutionsAppendix a Troubleshooting Application Start and End Protocol IP Address Enable Internet phone 5060 toIP address Phone Adapter Internet phone 53 to IP address Phone Adapter Internet phone 69 toPhone Adapter with 2 Ports for Voice-over-IP Application Start and End Protocol IP Address Enable Phone Adapter with 2 Ports for Voice-over-IP Phone Adapter with 2 Ports for Voice-over-IP Application Start and End Protocol IP Address Enable Frequently Asked Questions Pick up the phone and dial as you normally wouldCan I make calls while I’m browsing the Internet? Shared Resources Appendix B Windows HelpNetwork Neighborhood/My Network Places Appendix B Windows Help Appendix C Glossary Appendix C Glossary Phone Adapter with 2 Ports for Voice-over-IP Phone Adapter with 2 Ports for Voice-over-IP Phone Adapter with 2 Ports for Voice-over-IP Phone Adapter with 2 Ports for Voice-over-IP Appendix D Specifications Storage Humidity DimensionsMm x 101 mm x 15 mm Appendix E Warranty Information Limited WarrantyAppendix E Warranty Information Appendix F Regulatory Information FCC StatementAppendix F Regulatory Information Appendix G Contact Information Appendix G Contact Information