Linksys PAP2-VU manual Using the Phone Adapter’s Interactive Voice Response Menu

Page 14

Phone Adapter with 2 Ports for Voice-over-IP

Chapter 4: Using the Phone Adapter’s Interactive Voice Response Menu

Overview

Chapter 4 explains how you can use the Interactive Voice Response Menu to configure the Phone Adapter’s network settings. You may need to change these settings depending on the specifics of your local network setup. Use the phone’s keypad to enter your commands and select choices, and the Phone Adapter will respond with voice responses.

Accessing the Interactive Voice Response Menu

1.Use a telephone connected to the PHONE 1 or PHONE 2 port of the Phone Adapter.

2.Press **** (in other words, press the star key four times).

3.You will hear, “Configuration menu. Please enter option followed by the # (hash) key or hang up to exit.”

Refer to the following table that lists actions, commands, menu choices, and descriptions. After you select an option, press the # (hash) key. To exit the menu, hang up the telephone.

Using the Interactive Voice Response Menu

While entering a value, such as an IP address, you may exit without entering any changes. Press the * (star) key twice within half a second. Otherwise, the * will be treated as a decimal point or dot.

Chapter 4: Using the Phone Adapter’s Interactive Voice Response Menu

9

Overview

Image 14
Contents Phone Adapter Division of Cisco Systems, IncPage How to Use this Guide Copyright and TrademarksTable of Contents Back Panel Front PanelWhat’s in this Guide? IntroductionWelcome What’s in this Guide? Getting to Know the Phone Adapter Back Panel PortsPhone is being used or an incoming call has been detected Front PanelPhone Adapter’s LEDs are located on the front panel Overview Connecting the Phone AdapterInstructions for Connecting the Phone Adapter InternetConnect the Telephone Cable Remove the plate from the Phone Adapter’s bottom panel Placement OptionsStand Option Phone Adapter’s Interactive Voice Response MenuWall-Mount Option Measurement between Wall-Mount SlotsUsing the Interactive Voice Response Menu Using the Phone Adapter’s Interactive Voice Response MenuAccessing the Interactive Voice Response Menu Not press any other keys until you Use this command to enter Response MenuInteractive Voice Response Menu Key or hang up to exitEnter 0 to disable Has been enabled or disabled. If101 Enter 1 to enable Check Dhcp 100Subnet Mask Mask using Address usingStatic IP address When entering a Decimal point Network mask When entering a Decimal pointPhone Adapter Manual Reboot 732668 Address Address usingStatic gateway IP address When entering a Decimal point 131 Enter the IPConfiguring the Settings for Your Internet Phone Service Appendix a Troubleshooting Common Problems and SolutionsAppendix a Troubleshooting IP address Phone Adapter Internet phone 53 to Application Start and End Protocol IP Address EnableInternet phone 5060 to IP address Phone Adapter Internet phone 69 toPhone Adapter with 2 Ports for Voice-over-IP Application Start and End Protocol IP Address Enable Phone Adapter with 2 Ports for Voice-over-IP Phone Adapter with 2 Ports for Voice-over-IP Application Start and End Protocol IP Address Enable Frequently Asked Questions Pick up the phone and dial as you normally wouldCan I make calls while I’m browsing the Internet? Network Neighborhood/My Network Places Appendix B Windows HelpShared Resources Appendix B Windows Help Appendix C Glossary Appendix C Glossary Phone Adapter with 2 Ports for Voice-over-IP Phone Adapter with 2 Ports for Voice-over-IP Phone Adapter with 2 Ports for Voice-over-IP Phone Adapter with 2 Ports for Voice-over-IP Appendix D Specifications Mm x 101 mm x 15 mm DimensionsStorage Humidity Appendix E Warranty Information Limited WarrantyAppendix E Warranty Information Appendix F Regulatory Information FCC StatementAppendix F Regulatory Information Appendix G Contact Information Appendix G Contact Information