Linksys PAP2-VU manual Getting to Know the Phone Adapter, Back Panel Ports

Page 8

Phone Adapter with 2 Ports for Voice-over-IP

Chapter 2: Getting to Know the Phone Adapter

Back Panel Ports

The Phone Adapter’s ports are located on the back panel.

	Figure 2-1: Back Panel
PHONE 1 Port	For your primary Internet phone line, the PHONE 1 port allows you to connect your
	telephone to the Phone Adapter using the included telephone jack adapter (if necessary).
PHONE 2 Port	If you add a second Internet phone service provider line, then use the PHONE 2 port. It
	allows you to connect a second telephone (or fax machine) to the Phone Adapter using the
	included telephone jack adapter (if necessary).
ETHERNET Port	The ETHERNET port allows you to connect the Phone Adapter to your router or gateway
	using a Category 5 (or better) Ethernet network cable.

NOTE: These Phone ports do not carry any voltage.

POWER Port	The POWER port is where you will connect the included power adapter.
Chapter 2: Getting to Know the Phone Adapter		3

Back Panel Ports

Image 8

Contents Phone Adapter Division of Cisco Systems, IncPage How to Use this Guide Copyright and TrademarksTable of Contents Back Panel Front PanelWhat’s in this Guide? IntroductionWelcome What’s in this Guide? Getting to Know the Phone Adapter Back Panel PortsPhone is being used or an incoming call has been detected Front PanelPhone Adapter’s LEDs are located on the front panel Connecting the Phone Adapter Instructions for Connecting the Phone AdapterOverview InternetConnect the Telephone Cable Placement Options Stand OptionRemove the plate from the Phone Adapter’s bottom panel Phone Adapter’s Interactive Voice Response MenuWall-Mount Option Measurement between Wall-Mount SlotsUsing the Interactive Voice Response Menu Using the Phone Adapter’s Interactive Voice Response MenuAccessing the Interactive Voice Response Menu Use this command to enter Response Menu Interactive Voice Response MenuNot press any other keys until you Key or hang up to exitHas been enabled or disabled. If 101 Enter 1 to enableEnter 0 to disable Check Dhcp 100Address using Static IP address When entering a Decimal pointSubnet Mask Mask using Network mask When entering a Decimal pointAddress Address using Static gateway IP address When entering a Decimal pointPhone Adapter Manual Reboot 732668 131 Enter the IPConfiguring the Settings for Your Internet Phone Service Appendix a Troubleshooting Common Problems and SolutionsAppendix a Troubleshooting Application Start and End Protocol IP Address Enable Internet phone 5060 toIP address Phone Adapter Internet phone 53 to IP address Phone Adapter Internet phone 69 toPhone Adapter with 2 Ports for Voice-over-IP Application Start and End Protocol IP Address Enable Phone Adapter with 2 Ports for Voice-over-IP Phone Adapter with 2 Ports for Voice-over-IP Application Start and End Protocol IP Address Enable Frequently Asked Questions Pick up the phone and dial as you normally wouldCan I make calls while I’m browsing the Internet? Network Neighborhood/My Network Places Appendix B Windows HelpShared Resources Appendix B Windows Help Appendix C Glossary Appendix C Glossary Phone Adapter with 2 Ports for Voice-over-IP Phone Adapter with 2 Ports for Voice-over-IP Phone Adapter with 2 Ports for Voice-over-IP Phone Adapter with 2 Ports for Voice-over-IP Appendix D Specifications Mm x 101 mm x 15 mm DimensionsStorage Humidity Appendix E Warranty Information Limited WarrantyAppendix E Warranty Information Appendix F Regulatory Information FCC StatementAppendix F Regulatory Information Appendix G Contact Information Appendix G Contact Information