Linksys PAP2-VU manual Wall-Mount Option, Measurement between Wall-Mount Slots

Page 13

Phone Adapter with 2 Ports for Voice-over-IP

Wall-Mount Option

The Phone Adapter has two wall-mount slots on its back panel. The distance between the two slots is 58 mm (2.28 inches).

1.Determine where you want to mount the Phone Adapter.

2.Drill two holes into the wall. Make sure the holes are 58 mm (2.28 inches) apart.

3.Insert a screw into each hole, and leave 5 mm (0.2 inches) of its head exposed.

4.Maneuver the Phone Adapter so the wall-mount slots line up with the two screws.

5.Place the wall-mount slots over the screws and slide the Phone Adapter down until the screws fit snugly into the wall-mount slots.

Congratulations! The installation of the Phone Adapter is complete.

If you need to change any of the Phone Adapter’s network settings, proceed to “Chapter 4: Using the

Phone Adapter’s Interactive Voice Response Menu.”

8

Figure 3-7: Measurement between

Wall-Mount Slots

Chapter 3: Connecting the Phone Adapter Placement Options

Image 13

Contents Division of Cisco Systems, Inc Phone AdapterPage Copyright and Trademarks How to Use this GuideTable of Contents Front Panel Back PanelWelcome IntroductionWhat’s in this Guide? What’s in this Guide? Back Panel Ports Getting to Know the Phone AdapterPhone Adapter’s LEDs are located on the front panel Front PanelPhone is being used or an incoming call has been detected Instructions for Connecting the Phone Adapter Connecting the Phone AdapterOverview InternetConnect the Telephone Cable Stand Option Placement OptionsRemove the plate from the Phone Adapter’s bottom panel Phone Adapter’s Interactive Voice Response MenuMeasurement between Wall-Mount Slots Wall-Mount OptionAccessing the Interactive Voice Response Menu Using the Phone Adapter’s Interactive Voice Response MenuUsing the Interactive Voice Response Menu Interactive Voice Response Menu Use this command to enter Response MenuNot press any other keys until you Key or hang up to exit101 Enter 1 to enable Has been enabled or disabled. IfEnter 0 to disable Check Dhcp 100Static IP address When entering a Decimal point Address usingSubnet Mask Mask using Network mask When entering a Decimal pointStatic gateway IP address When entering a Decimal point Address Address usingPhone Adapter Manual Reboot 732668 131 Enter the IPConfiguring the Settings for Your Internet Phone Service Common Problems and Solutions Appendix a TroubleshootingAppendix a Troubleshooting Internet phone 5060 to Application Start and End Protocol IP Address EnableIP address Phone Adapter Internet phone 53 to IP address Phone Adapter Internet phone 69 toPhone Adapter with 2 Ports for Voice-over-IP Application Start and End Protocol IP Address Enable Phone Adapter with 2 Ports for Voice-over-IP Phone Adapter with 2 Ports for Voice-over-IP Application Start and End Protocol IP Address Enable Pick up the phone and dial as you normally would Frequently Asked QuestionsCan I make calls while I’m browsing the Internet? Shared Resources Appendix B Windows HelpNetwork Neighborhood/My Network Places Appendix B Windows Help Appendix C Glossary Appendix C Glossary Phone Adapter with 2 Ports for Voice-over-IP Phone Adapter with 2 Ports for Voice-over-IP Phone Adapter with 2 Ports for Voice-over-IP Phone Adapter with 2 Ports for Voice-over-IP Appendix D Specifications Storage Humidity DimensionsMm x 101 mm x 15 mm Limited Warranty Appendix E Warranty InformationAppendix E Warranty Information FCC Statement Appendix F Regulatory InformationAppendix F Regulatory Information Appendix G Contact Information Appendix G Contact Information