Chapter 3: Installing the Enclosure
Using the Plastic Splice Tray
13.Close the inner door, verifying that the cables are not pinched, and then close the outer doors.
14.Secure the enclosure until it is time to install the gateway and other cables.
To use the plastic
1.Strip the buffer tube away, starting 10.5 in. (26.67 cm) beyond the sheath, leaving approximately 33 in. (83.82 cm) of fiber exposed.
2.Insert a small clear wire tie through the holes in the left upper and lower mounting tabs on the bottom portion, as shown in Figure 25.
1180
Figure 25. Inserting the Wire Ties
3.Route the buffer tube from the drop cable to the lower left corner of the splice tray and secure the tube to the splice tray with the wire tie, as shown in Figure 26.
1181
Figure 26. Securing the Buffer Tube
48 | Section I: Outdoor Installation |