ADS Technologies version 5.2b1 Connect to the USB Interface, Connecting to the USB Interface

Page 13

Hardware Installation

2.6 Connect to the USB Interface

Step 1. Plug the Type-B (square-shaped) end of the USB detachable cable (included) into the USB port of the modem.

Step 2. Plug the Type-A (flat-shaped) end of the USB detachable cable into the USB port of your PC.

Step 3. Do not turn on the power switch until software installation is

complete. Proceed to Section 3.11 “Installing the Software Drivers.”

Figure 2.7 Connecting to the USB Interface

2-7

Image 13

Contents NetDSL 800 Adsl Modem Version 5.2b1 User’s Guide ArescomTrademark CopyrightSoftware Installation Hardware InstallationBefore You Begin NetDSL ManagerStatus Feature ConfigurationTools Feature TroubleshootingBefore You Begin Hot FeaturesPackage Includes Bridge Packet Filtering TableInformation You Will Need Minimum System RequirementsDiagram of the NetDSL Hardware InstallationBack Panel Interfaces Front Panel Interfaces Diag DiagnosticSetup Instructions Safety FirstPersonal Safety Product HandlingConnect to the Ethernet Connecting to a Ethernet Port on a PCConnecting to the Non-Uplink Port on a Network Hub Connect to the Adsl Interface Connecting the DSL InterfaceConnect to the USB Interface Connecting to the USB InterfaceConnecting to a Power Supply Connect to PowerAbout TCP/IP InstallationDetecting TCP/IP Windows 95/98 Configuring TCP/IP Windows 95/98 Installing TCP/IP Windows 95/98Detecting TCP/IP in Windows Installing TCP/IP in WindowsDetecting TCP/IP Windows NT Configuring TCP/IP in Windows10Configuring TCP/IP Windows NT Installing TCP/IP Windows NTUSB Installation Step 11Installing the Software DriversUSB Installation Step Continue USB Installation Step Page NetDSL Manager Installing the NetDSL SoftwareLaunching the NetDSL Manager NetDSL Manager Multiple Routers/Bridges Selection WindowSubnet window Tures NetDSL Manager OverviewNetDSL Manager NetDSL Manager 6NetDSL Software User’s Guide Configuration General Configuration Outline of ConfigurationAdministrative Security General ConfigurationBridge Packet Filter Modify Bridge Packet Filter LAN Configuration LAN ConfigurationNetDSL. Click Exit to return to the NetDSL Manager DSL Configuration DSL ConfigurationATM PVC Properties ATM PVC PropertiesATM Service Type ATM Service TypeClick Save Configuration File As Configuration FileConfiguration 12NetDSL Software User’s Guide Main Status Panel Status FeatureEvent Log in Status LED Panel Tab in Status LED PanelTraffic Counter Tab in Status Traffic CounterDSL Status Table Tab in Status DSL Status TableStatus Feature 6NetDSL Software User’s Guide Upgrade Firmware Tools FeatureUpgrade Firmware Tab in Tools Reset Router Reset Router/BridgeTools Feature 4NetDSL Software User’s Guide Cannot Detect the Modem TroubleshootingModem and PC are Not in the Same Subnet Cannot Upgrade the FirmwareTerminology for Configuration Parameters About Configuration ParametersExplaining IP Addresses Bridge Packet Filtering Virtual Channel IdentifierEthernet Cable Pinout 2NetDSL Software User’s Guide Limited Warranty Warranty InformationStandard Warranty Service Limitation of Liability Warranties ExclusiveBefore Returning a Product for Repair Warranty RegistrationReturn Instructions Return Instructions 4NetDSL Software User’s Guide Declaration of Conformity