ADS Technologies version 5.2b1 manual Connecting to the Non-Uplink Port on a Network Hub

Page 11

Hardware Installation

ports on a hub.

Figure 2.5 Connecting to the Non-Uplink Port on a Network Hub

Step 4. The LAN LINK LED on the front panel should be lit green to indicate a valid Ethernet connection. If the LAN LINK LED is not lit, then repeat steps 1 through 3.

Note: See Appendix B Ethernet Cable Pinout for further information about the differences between a straight-through cable and a crossover cable.

2-5

Image 11

Contents NetDSL 800 Adsl Modem Version 5.2b1 User’s Guide ArescomTrademark CopyrightNetDSL Manager Hardware InstallationSoftware Installation Before You BeginTroubleshooting ConfigurationStatus Feature Tools FeatureBridge Packet Filtering Table Hot FeaturesBefore You Begin Package IncludesInformation You Will Need Minimum System RequirementsBack Panel Interfaces Hardware InstallationDiagram of the NetDSL Front Panel Interfaces Diag DiagnosticProduct Handling Safety FirstSetup Instructions Personal SafetyConnect to the Ethernet Connecting to a Ethernet Port on a PCConnecting to the Non-Uplink Port on a Network Hub Connect to the Adsl Interface Connecting the DSL InterfaceConnect to the USB Interface Connecting to the USB InterfaceConnecting to a Power Supply Connect to PowerDetecting TCP/IP Windows 95/98 InstallationAbout TCP/IP Configuring TCP/IP Windows 95/98 Installing TCP/IP Windows 95/98Detecting TCP/IP in Windows Installing TCP/IP in WindowsDetecting TCP/IP Windows NT Configuring TCP/IP in Windows10Configuring TCP/IP Windows NT Installing TCP/IP Windows NTUSB Installation Step 11Installing the Software DriversUSB Installation Step Continue USB Installation Step Page Launching the NetDSL Manager Installing the NetDSL SoftwareNetDSL Manager NetDSL Manager Multiple Routers/Bridges Selection WindowSubnet window Tures NetDSL Manager OverviewNetDSL Manager NetDSL Manager 6NetDSL Software User’s Guide Configuration General Configuration Outline of ConfigurationAdministrative Security General ConfigurationBridge Packet Filter Modify Bridge Packet Filter LAN Configuration LAN ConfigurationNetDSL. Click Exit to return to the NetDSL Manager DSL Configuration DSL ConfigurationATM PVC Properties ATM PVC PropertiesATM Service Type ATM Service TypeClick Save Configuration File As Configuration FileConfiguration 12NetDSL Software User’s Guide Main Status Panel Status FeatureEvent Log in Status LED Panel Tab in Status LED PanelTraffic Counter Tab in Status Traffic CounterDSL Status Table Tab in Status DSL Status TableStatus Feature 6NetDSL Software User’s Guide Upgrade Firmware Tools FeatureUpgrade Firmware Tab in Tools Reset Router Reset Router/BridgeTools Feature 4NetDSL Software User’s Guide Cannot Detect the Modem TroubleshootingModem and PC are Not in the Same Subnet Cannot Upgrade the FirmwareExplaining IP Addresses About Configuration ParametersTerminology for Configuration Parameters Bridge Packet Filtering Virtual Channel IdentifierEthernet Cable Pinout 2NetDSL Software User’s Guide Standard Warranty Service Warranty InformationLimited Warranty Limitation of Liability Warranties ExclusiveReturn Instructions Warranty RegistrationBefore Returning a Product for Repair Return Instructions 4NetDSL Software User’s Guide Declaration of Conformity