ADS Technologies version 5.2b1 manual ATM Service Type

Page 40

Configuration

ATM Service Type

Click on ATM Service Type in the left panel.

Figure 5.7 ATM Service Type

This panel allows you to select the ATM Service Type for the ATM interface. Presently, Unspecified Bit Rate (UBR) and Constant Bit Rate (CBR) are available. You can specify the Peak Cell Rate (PCR) in kbps. This panel also allows you to specify the period for the Operations And Maintenance (OAM) F5 (virtual channel) timer. If the period is set to zero, the OAM F5 loopback cell is not sent. If the period is set to a non-zero value, the loopback cell is transmitted to the remote peer according to the specified period. Note that the local peer will always respond to a loopback cell that is transmitted by the remote peer.

Once you have finished setting these parameters, click Apply to review the parameters you have entered and then click Finish to send settings to the NetDSL. Click Exit to return to the NetDSL Manager.

5-10NetDSL Software User’s Guide

Image 40

Contents Arescom NetDSL 800 Adsl Modem Version 5.2b1 User’s GuideCopyright TrademarkHardware Installation Software InstallationBefore You Begin NetDSL ManagerConfiguration Status FeatureTools Feature TroubleshootingHot Features Before You BeginPackage Includes Bridge Packet Filtering TableMinimum System Requirements Information You Will NeedDiagram of the NetDSL Hardware InstallationBack Panel Interfaces Diag Diagnostic Front Panel InterfacesSafety First Setup InstructionsPersonal Safety Product HandlingConnecting to a Ethernet Port on a PC Connect to the EthernetConnecting to the Non-Uplink Port on a Network Hub Connecting the DSL Interface Connect to the Adsl InterfaceConnecting to the USB Interface Connect to the USB InterfaceConnect to Power Connecting to a Power SupplyAbout TCP/IP InstallationDetecting TCP/IP Windows 95/98 Installing TCP/IP Windows 95/98 Configuring TCP/IP Windows 95/98Installing TCP/IP in Windows Detecting TCP/IP in WindowsConfiguring TCP/IP in Windows Detecting TCP/IP Windows NTInstalling TCP/IP Windows NT 10Configuring TCP/IP Windows NT11Installing the Software Drivers USB Installation StepUSB Installation Step Continue USB Installation Step Page NetDSL Manager Installing the NetDSL SoftwareLaunching the NetDSL Manager Multiple Routers/Bridges Selection Window NetDSL ManagerSubnet window NetDSL Manager Overview TuresNetDSL Manager NetDSL Manager 6NetDSL Software User’s Guide Configuration Outline of Configuration General ConfigurationGeneral Configuration Administrative SecurityBridge Packet Filter Modify Bridge Packet Filter LAN Configuration LAN ConfigurationNetDSL. Click Exit to return to the NetDSL Manager DSL Configuration DSL ConfigurationATM PVC Properties ATM PVC PropertiesATM Service Type ATM Service TypeConfiguration File Click Save Configuration File AsConfiguration 12NetDSL Software User’s Guide Status Feature Main Status PanelEvent Log in Status LED Panel LED Panel Tab in StatusTraffic Counter Traffic Counter Tab in StatusDSL Status Table DSL Status Table Tab in StatusStatus Feature 6NetDSL Software User’s Guide Tools Feature Upgrade FirmwareUpgrade Firmware Tab in Tools Reset Router/Bridge Reset RouterTools Feature 4NetDSL Software User’s Guide Troubleshooting Cannot Detect the ModemCannot Upgrade the Firmware Modem and PC are Not in the Same SubnetTerminology for Configuration Parameters About Configuration ParametersExplaining IP Addresses Virtual Channel Identifier Bridge Packet FilteringEthernet Cable Pinout 2NetDSL Software User’s Guide Limited Warranty Warranty InformationStandard Warranty Service Warranties Exclusive Limitation of LiabilityBefore Returning a Product for Repair Warranty RegistrationReturn Instructions Return Instructions 4NetDSL Software User’s Guide Declaration of Conformity