ADS Technologies version 5.2b1 Installing TCP/IP Windows NT, 10Configuring TCP/IP Windows NT

Installing TCP/IP in Windows® NT 4.0

3.9Installing TCP/IP

in Windows® NT 4.0

Note: Consult your Network Administrator if you do not have authorization to change settings for your PC.

Step 1. From the Protocols tab in the Network window, click Add.

Step 2. Select TCP/IP Protocol listed under Network Protocols, Click OK.

Step 3. Check to verify that TCP/IP is listed under Network Protocols, then Click OK.

A.If you do not see TCP/IP listed under Network Protocols, you have not installed TCP/IP. Repeat steps 1 - 3.

B.If you see TCP/IP listed under Network Protocols, then you have

successfully installed TCP/IP. Proceed to configuration directions for Windows® NT 4.0 in Section 3.7.

3.10Configuring TCP/IP in

Windows® NT 4.0

Step 1. From the Protocols tab, select TCP/IP (for Ethernet adapters) listed under Network Protocol and then click Properties.

Step 2. Select the IP Address tab.

You now have the option of using either dynamic or static IP addressing.

To enable dynamic IP addressing

Step 1. Click Obtain an IP Address from DHCP Server.

Step 2. OPTIONAL* Click the DNS tab and select Disable DNS. If you previously entered any parameters, clear all pre-existing settings.*

Step 3. Click OK to exit Network Properties window. Proceed to Chapter 4 “NetDSL Manager.”

*If specifically required by your ISP, you may need to enter DNS information.

To enable static IP addressing

Step 1. To enable static addressing, click Specify an IP Address and then type the IP Address, Subnet Mask, and Gateway IP Address(for your PC).

Step 2. Click the DNS tab. Enter the Host name, Domain name, and DNS Service Search Order (for your LAN).

Step 3. Click OK to exit Network Properties window. Proceed to Chapter 4 “NetDSL Manager.”

Software Installation 3-5