NetDSL Manager
For further information on the available features, refer to the NetDSL Manager Overview later in this section.
Note: After the initial modem configuration, you can reset the modem configuration parameters at any time from the Tools feature. Just select the Reset Router/Mode tab, click on the “Delete Configurations and Reset to Manufacturer Mode” box, and then click Reset Router.
Multiple Routers/Bridges Selection Window
When you run the NetDSL Manager program the Multiple Routers/Bridges Selection window will appear. The program is searching for the NetDSL modems attached to the same network as your PC. This procedure may take a few seconds.
Figure 4.1 Multiple Routers/Bridges Selection
After a few seconds, the NetDSL Manager will display a message indicating that it has found one or more modems on your local network. The window lists all detected modems, both configured and unconfigured. From this list you can select the specific modem that you wish to configure or
If the modem is not in the same subnet as the managing PC, a Subnet window appears and allows you to choose three selections. You can Change the router’s IP address and keep the other configuration, Reset the router to Manufacture mode and delete the configuration, or Change your computer’s TCP/IP settings. After you have made you choice, click Next to proceed.