TRACER 5045 System Manual | Section 5 User Interface Guide |
|
|
>TRACER SYSTEM CONFIGURATION
Figure 4 shows the TRACER 5045 System Configuration menu page. System configuration parameters for both the local and remote TRACER 5045 units are available through this menu page.
Figure 4. TRACER 5045 System Configuration
Press <1> from any menu in the TRACER 5045 VT100 menu structure to access the TRACER System Configuration menu page.
>TRACER SYSTEM CONFIGURATION > RX POWER
Displays the approximate receiver levels (for both the local and remote units) using a series of symbols (#). The more symbols (#) displayed, the stronger the signal. If the link is down and remote end data is unavailable, DATA NOT AVAILABLE displays in place of the symbols (#). This parameter is display only.
>TRACER SYSTEM CONFIGURATION > TX POWER
Allows the transmitter levels (for both the local and remote units) to be adjusted. The current transmitter level is displayed using a series of symbols (#). The more symbols (#) displayed, the stronger the signal. If the link is down and remote end data is unavailable, DATA NOT AVAILABLE displays in place of the symbols (#).
Reducing the transmitter power of the remote TRACER 5045 could negatively impact the TRACER RF link.
© 2003 ADTRAN, Inc. | 45 |