ADTRAN system manual Reviewing the Tracer 5045 Rear Panel Design

TRACER 5045 System Manual		Section 3 Engineering Guidelines
	Table 2. TRACER 5045 LEDs
For these LEDs...	This color light...	Indicates that...
PWR	Green (solid)	the TRACER 5045 is connected to a power source.
	Off	the TRACER 5045 is not currently powered up.
TST	Amber (solid)	there is an active test being performed by the system.
	Green	there is a valid 10/100BaseT/TX link.
LAN (1–4)
	Amber (blinks with activity)	there is data activity (transmit or receive data) on the
		10/100BaseT/TX LAN interface.
	Green	there is a valid wireless link.
WAN
	Amber (blinks with activity)	there is data activity (transmit or receive data) over the wireless
		link.
PLAN A	Green (solid)	the TRACER 5045 is transmitting on Frequency Plan A.
	Off	the TRACER 5045 is not transmitting on Frequency Plan A.
PLAN B	Green (solid)	the TRACER 5045 is transmitting on Frequency Plan B.
	Off	the TRACER 5045 is not transmitting on Frequency Plan B.
RF LOW	Red (solid)	the RSSI level is below suggested minimum threshold
		(approximately 10 dBm above the minimum receive sensitivity).
RF DOWN	Red (solid)	there is a communication problem between the local and remote
		TRACER 5045 systems.

4.REVIEWING THE TRACER 5045 REAR PANEL DESIGN

Figure 2 identifies the various features of the TRACER 5045 rear panel and Table 1 on page 26 provides a brief description of each interface.

A	E	G
RS232 Interface	DC Power	Antenna
(VT100 Terminal)	Connection	Connector

1		2	3	4
LNK	ACT LNK	ACT LNK	ACT LNK	ACT
	10/100 BASE - T/ TX

B		D	F	H
	C
				Ground
Test	Ethernet	Alarm	Fuse	Lug
		Contacts

Interfaces

Figure 2. TRACER 5045 Rear Panel

612805045L1-1A © 2003 ADTRAN, Inc. 27