Asus P5SD2-FM manual Bios menu screen, Menu bar, Navigation keys

Page 45

2.2.1BIOS menu screen

Menu items

Menu bar

Configuration fields

General help

System Time

System Date

Legacy Diskette A

Primary IDE Master Primary IDE Slave

Secondary IDE Master

Secondary IDE Slave

Third IDE Master

Third IDE Slave

Fourth IDE Master

Fourth IDE Slave

SATA Mode Selection

System Information

[10:55:25]

[FRI,03/10/2006] [1.44M, 3.5 in]

[ST320410A] [ASUS CD-S520/A] [Not Detected] [Not Detected] [Not Detected] [Not Detected] [Not Detected] [Not Detected] [4P(IDE)+4S(IDE)]

Use [ENTER], [TAB] or [SHIFT-TAB] to select a field.

Use [+] or [-] to configure the System Time.

Sub-menu items

Navigation keys

2.2.2Menu bar

The menu bar on top of the screen has the following main items:

Main

For changing the basic system configuration

Advanced

For changing the advanced system settings

Power

For changing the advanced power management (APM)

 

configuration

Boot

For changing the system boot configuration

Exit

For selecting the exit options and loading default

 

settings

To select an item on the menu bar, press the right or left arrow key on the keyboard until the desired item is highlighted.

2.2.3Navigation keys

At the bottom right corner of a menu screen are the navigation keys for that particular menu. Use the navigation keys to select items in the menu and change the settings.

Some of the navigation keys differ from one screen to another.

ASUS P5SD2-FM

2-3

Image 45
Contents Motherboard Copyright 2006 ASUSTeK Computer INC. All Rights Reserved E2471 First Edition MarchContents Bios setup APM Canadian Department of Communications Statement Federal Communications Commission StatementOperation safety Electrical safetyP5SD2-FM specifications summary Internal connectors Support CD contents Form Factor Page Hardware1 information Before you proceed Placement direction Motherboard overviewScrew holes P5SD2-FM Motherboard layoutLayout Contents Internal connectors Central Processing Unit CPU Installing the CPURetention tab Load lever PnP cap Asus P5SD2-FM Installing the CPU heatsink and fan Push down two fasteners at a time Uninstalling the CPU heatsink and fan Narrow end of the groove Memory Configurations System memoryDimm sockets location To install a Dimm Installing a DimmRemoving a Dimm Break on the socketInstalling an expansion card Configuring an expansion cardExpansion slots Interrupt assignments Standard interrupt assignmentsIRQ assignments for this motherboard PCI Express PCI Express x16 slotPCI slots Clear RTC RAM Clrtc JumpersBios Recovery 3-pin RECOVERY1 USB device wake-up 3-pin USBPW12, USBPW34, USBPW56, USBPW78 Password SkipConnectors Rear panel connectorsLAN port LED indications Port Channel Headset Audio 2, 4, 6, or 8-channel configurationInternal connectors Floppy disk drive connector 34-1 pin FloppyPower LED connector 3-1 pin Pled IDE connectors 40-1 pin PRIIDE, Secide SATA4 Serial ATA Master/Slave connectorsSpeaker out connector 4-pin Speaker Digital audio connector 3 pin SPDIFO2 USB connectors 10-1 pin USB56, USB78CPU ATX power connectors 24-pin EATXPWR, 4-pin ATX12VFront panel audio connector 10-1 pin Fpaudio Internal audio connector 4-pin AUXSystem power LED Green 2-pin Pled System panel connector 10-1 pin FpanelPower/Soft-off button Black 2-pin Pwrsw Reset button Blue 2-pin ResetHardware information Bios setup Bios setup program Bios menu screen Menu barNavigation keys Menu items Configuration fieldsSub-menu items Pop-up windowMain menu Legacy Diskette a DisabledSystem Time System Date Day xx/xx/xxxxPrimary, Secondary, Third, and Fourth IDE Master/Slave LBA/Large Mode AutoType Auto Block Multi-sector Transfer AutoPIO Mode Auto Sata Mode Selection 4PIDE+4SIDEDMA Mode Auto 32Bit Data Transfer EnabledSystem Information ProcessorSystem Memory Advanced menu CPU Configuration Auto Detect CPU Frequency Enabled ChipsetCPU Internal Thermal Control Auto Primary Graphics Adapter PCI Express NorthBridge SIS649 Chipset ConfigurationOnboard SiS966 LAN Device Enabled SouthBridge SiS966 Chipset ConfigurationSerial Port1 Address 3F8/IRQ4 Onboard 1394 Controller EnabledPCI PnP Clear Nvram NoPlug and Play O/S No OffBoard PCI/ISA IDE Card Auto Allocate IRQ to PCI VGA YesIRQ-xx assigned to PCI Device DMA Channel x PCI DeviceUSB Configuration Power menu Power Button Mode Off/On APM ConfigurationAC Power Loss Restart Previous State Power On By PCI Devices DisabledMB Temperature xxxoC/xxxoF CPU Temperature xxxoC/xxxoF Power On By RTC Alarm DisabledSmart Q-Fan Function Enabled Hardware MonitorBoot menu Boot Device Priority1st ~ xxth Boot Device xxx Drive Boot Settings Configuration Security Change Supervisor PasswordChange User Password User Access Level Full AccessClear User Password Password Check SetupExit menu Exit & Save Changes Load Setup DefaultsExit & Discard Changes Discard Changes