GREY | EAR (Output) |
BLACK | REM (remote control) |
1.3.2 Saving a Program
To save a program on cassette, rewind the cassette to a blank section, then put the cassette recorder into RECORD.
To save a program that is in the file area type :
CSAVE“filnam”
Where filnam is the file name you wish the program to be saved under. It is usually good practice to save the program twice (on the same cassette), as a protection against corruption on the tape.
To save a program that is in the file area, first load it into the text area by using the LOAD command :
LOAD“filnam”
then save it on cassette as above.
1.3.3 Loading a Program
To load a program from cassette, rewind the cassette to the start of the file, then put the cassette recorder into PLAY, then type:
CLOAD“filnam”
Where filnam is the file name of the program you wish to load. If the file name is left out, then the next program on the tape will be loaded.
To save the program in the file area use the command :
SAVE“filnam”
4 | Section 1. INTRODUCTION |