EnGenius Technologies EAP9550 manual Security, Encryption Disabled

Page 15

∙Data rate: You may select a data rate from the drop-down list, however, it is recommended to select auto. This is also known as auto-fallback.

∙N Data Rate: You may select N data rate from the drop-down list, however, it is recommended to select auto.

∙Channel Bandwidth: Select channel bandwidth (Auto 20/40MHz or 20MHz)

∙Preamble Type: Select a short or long preamble. For optimum performance it is recommended to also configure the client device as the same preamble type.

∙CTS Protection: CTS (Clear to Send) can be always enabled, auto, or disabled. By enabled CTS, the Access Point and clients will wait for a ‘clear’ signal before transmitting. It is recommended to select auto.

4.2.1.4. Security

Encryption: Disabled

Image 15

Contents EnGenius EAP9550 Table of Content Page Introduction Features and BenefitsSystem Requirement Package ContentsUnderstanding the Hardware Hardware InstallationAccess Point WDS BridgeUniversal Repeater Operation Mode SystemStatus Dhcp Schedule Event Log Monitor Detail Click into detail to see historical record 1. AP Status WirelessBasic Radio To enable/disable wireless signalAdvanced Security Encryption DisabledEncryption WEP Encryption WPA pre-shared key Encryption WPA Radius Filter Client List WPSVlan Only Available in AP modeWMM WDS Bridge Status Basic Security Disabled Security WEP Security WPA pre-shared key Advanced WMM Universal Repeater AP Status Basic Advanced Encryption Disabled Encryption WEP Page Encryption WPA pre-shared key Filter WPS WMM Status LAN NetworkPage Admin ManagementSnmp UPnP Configure ResetFirmware Tools Time SettingPower Saving Diagnosis LED Control LogoutFederal Communication Commission Interference Statement Appendix a FCC Interference StatementAppendix B IC Interference Statement