EnGenius Technologies EAP9550 manual Understanding the Hardware, Hardware Installation

Page 6

2.Understanding the Hardware

2.1.Hardware Installation

1Place the unit in an appropriate place after conducting a site survey.

2Plug one end of the Ethernet cable into the RJ-45 port on the rear panel of the device and another end into your PC/Notebook.

3Insert the DC-inlet of the power adapter into the port labeled “DC-IN” and the other end into the power socket on the wall.

4Regarding wall mount please use Φ3.0 screw for fixing.

This diagram depicts the hardware configuration

PC

Ethernet

Access Point

AC/DC cable

Power Outlet

Φ3.0 screw

Reset Button 2~10 sec Reboot

Over 10 sec Reset to Default

Image 6

Contents EnGenius EAP9550 Table of Content Page Features and Benefits IntroductionPackage Contents System RequirementHardware Installation Understanding the HardwareAccess Point WDS BridgeUniversal Repeater Operation Mode SystemStatus Dhcp Schedule Event Log Monitor Detail Click into detail to see historical record Wireless 1. AP StatusRadio To enable/disable wireless signal BasicAdvanced Encryption Disabled SecurityEncryption WEP Encryption WPA pre-shared key Encryption WPA Radius Filter WPS Client ListOnly Available in AP mode VlanWMM WDS Bridge Status Basic Security Disabled Security WEP Security WPA pre-shared key Advanced WMM Universal Repeater AP Status Basic Advanced Encryption Disabled Encryption WEP Page Encryption WPA pre-shared key Filter WPS WMM Network Status LANPage Admin ManagementSnmp UPnP Configure ResetFirmware Time Setting ToolsPower Saving Diagnosis Logout LED ControlAppendix a FCC Interference Statement Federal Communication Commission Interference StatementAppendix B IC Interference Statement