EnGenius Technologies EAP9550 manual Appendix B IC Interference Statement

Page 46

Appendix B – IC Interference Statement

Industry Canada statement:

This device complies with RSS-210 of the Industry Canada Rules. Operation is subject to the following two conditions:

(1)This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

IMPORTANT NOTE:

Radiation Exposure Statement:

This equipment complies with IC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body.

This device has been designed to operate with an antenna having a maximum gain of 2 dBi. Antenna having a higher gain is strictly prohibited per regulations of Industry Canada. The required antenna impedance is 50 ohms.

Image 46

Contents EnGenius EAP9550 Table of Content Page Features and Benefits IntroductionPackage Contents System RequirementHardware Installation Understanding the HardwareWDS Bridge Access PointUniversal Repeater System Operation ModeStatus Dhcp Schedule Event Log Monitor Detail Click into detail to see historical record Wireless 1. AP StatusRadio To enable/disable wireless signal BasicAdvanced Encryption Disabled SecurityEncryption WEP Encryption WPA pre-shared key Encryption WPA Radius Filter WPS Client ListOnly Available in AP mode VlanWMM WDS Bridge Status Basic Security Disabled Security WEP Security WPA pre-shared key Advanced WMM Universal Repeater AP Status Basic Advanced Encryption Disabled Encryption WEP Page Encryption WPA pre-shared key Filter WPS WMM Network Status LANPage Management AdminSnmp UPnP Reset ConfigureFirmware Time Setting ToolsPower Saving Diagnosis Logout LED ControlAppendix a FCC Interference Statement Federal Communication Commission Interference StatementAppendix B IC Interference Statement