EnGenius Technologies EAP9550 manual Advanced

Page 26

4.2.2.3. Advanced

∙Fragment Threshold: Packets over the specified size will be fragmented in order to improve performance on noisy networks. Specify a value between 256 and 2346. The default value is 2346.

∙RTS Threshold: Packets over the specified size will use the RTS/CTS mechanism to maintain performance in noisy networks and preventing hidden nodes from degrading the performance. Specify a value between 0 and 2347. The default value is 2347.

∙Data rate: You may select a data rate from the drop-down list, however, it is recommended to select auto. This is also known as auto-fallback.

∙N Data Rate: You may select N data rate from the drop-down list, however, it is recommended to select auto.

∙Channel Bandwidth: Select channel bandwidth. (Auto 20/40MHz or 20MHz)

∙Preamble Type: Select a short or long preamble. For optimum performance it is recommended to also configure the client device as the same preamble type.

∙CTS Protection: CTS (Clear to Send) can be always enabled, auto, or disabled. By enabled CTS, the Access Point and clients will wait for a ‘clear’ signal before transmitting. It is recommended to select auto.

Page 25 Page 27
Image 26
Page 25 Page 27
Contents EnGenius EAP9550 Table of Content Page Features and Benefits IntroductionPackage Contents System RequirementHardware Installation Understanding the HardwareUniversal Repeater Access PointWDS Bridge Status Operation ModeSystem Dhcp Schedule Event Log Monitor Detail Click into detail to see historical record Wireless 1. AP StatusRadio To enable/disable wireless signal BasicAdvanced Encryption Disabled SecurityEncryption WEP Encryption WPA pre-shared key Encryption WPA Radius Filter WPS Client ListOnly Available in AP mode VlanWMM WDS Bridge Status Basic Security Disabled Security WEP Security WPA pre-shared key Advanced WMM Universal Repeater AP Status Basic Advanced Encryption Disabled Encryption WEP Page Encryption WPA pre-shared key Filter WPS WMM Network Status LANPage Snmp AdminManagement UPnP Firmware ConfigureReset Time Setting ToolsPower Saving Diagnosis Logout LED ControlAppendix a FCC Interference Statement Federal Communication Commission Interference StatementAppendix B IC Interference Statement
Top Page Image Contents