Canon DU7-1175-000 service manual Green Belt REPLACEMENT, Paper Exit Side, FC3-3633-0000

Page 21

AFTER ASSEMBLY

4.6GREEN BELT REPLACEMENT, PAPER EXIT SIDE

The following step-by-step directions inform you how to remove and then assembly the components necessary to access the Paper Exit Side Aligner Green Belt,

P/N FC3-3633-0000

It will help you to reference your Professional Puncher-A1 Service Manual part drawings as you follow this process.

Special Tools Required:

Twelve inch metal ruler or similar straight edge.

Phillips Head Screw Driver 7” or less in total length.

Alan wrenches.

Nut Driver

Rare Earth Magnet Snake Neck (optional – good for retrieving any hardware that happens to fall in hard to reach spots)

Snap Ring pliers

E-Ring tool

NOTE: During assembly, be sure not to over tighten any of the mounting screws.

Step 1: Disconnect the Professional Puncher-A1 from Power. Retain the power cord in your possession for your safety.

Step 2: Disconnect the Communication Cable to the Finisher.

Step 3: Unlatch the CANON Professional Puncher-A1 from both the Finisher and the Printer.

NOTE: You must first remove the screw that secures the latch in place (if so equipped).

Step 4: Open the front door (A) of the Professional Puncher-A1.

21

Image 21
Contents Professional Puncher-A1 Table of Contents Professional PUNCHER-A1 FAQ’S IntroductionIntroduction X 11 LEF Only Die SetsPunch Pattern Samples North America Letter Shown Unpacking InstallationUnit SET-UP Unit OperationFelt PAD Magnet Sheild Shoulder Bolt With Spring INSPECTION, Cleaning and Lubrication MaintenanceDIE SET Maintenance Preventative Maintenance Schedule Setting the Right ExpectationsProduct Positioning Adjustment and Special Procedures DIE SET Position Cradle ADJUSTMENT, Centering Punched HolesTool Recommendations Punched Hole Alignment Checking Turn Counter Clockwise Removal of Punch Module Symptom Green Belt REPLACEMENT, Aligner Panel REMOVAL, ExplanationPaper will stop moving through the Punch paper path CauseGreen Belt REPLACEMENT, Paper Entrance Side Procedure to Replace Aligner BeltsFC3-3633-0000 Binder Side Page Stretch Sensor Flexible Shaft Align & FIX Screws Instal J2 Shaft Green Belt REPLACEMENT, Paper Exit Side Binder Side Paper Enterance Aligner Drive Belt Assy Assembly Process Assemble Back Page General Description Installation StepsBack Gauge Assy Front Side To Clear a Paper JAM Software Update Procedure Version Tools Required Software Update Procedure VersionBootloaderg COM5 Theory of Operation Technical TroubleshootingInputs OutputsSerial Eeprom Control General TroubleshootingStepper #1 Control Punch ControlPage Symptom Probable Cause Corrective Action Troubleshooting Guide ChartPage OUBLRevHOOTING Guide Chart Operating Controls Punching PatternsChanging the Punch DIE Sets Step Paper Chip DrawerService Problem SOLVING, Operator Level Professional PUNCHER-A1Problem Probable Cause SPECIFICATIONS, 208V & 230/240V Professional PUNCHER-A1 Specifications