Canon DU7-1175-000 service manual Assembly Process

Page 25

metal (w/o a belt) Green Belt Aligner Roller itself. Note that the two metal surfaces are flush.

Step 12: Remove the Green Belt Aligner Roller Assembly by removing the “4” screws.

Important: Leave the Coupler attached.

Assembly Process

Step 13: Stretch the new green belt onto the Aligner Roller Assembly, green side out.

•Take care when handling the Aligner Roller Assembly so as not to damage the Flex Coupling.

•Rotate the shaft to confirm that the belt tracks properly.

Step 14: Slide the Aligner into place, loosely attach the “4” Pan Head Screws with the “4” Lock Washers.

ROTATE

STRETCH

BELT

Check that the metal surface of the Aligner Roller Assembly is flush with the Sheet Metal surface of the Paper Guide. A 12” metal ruler works well to check this adjustment. Slip the ruler under the green belt and press it flat against the two surfaces. Adjust the Aligner and snug the screws when perfectly flush.

NOTE: The green belt should look like the drawing shown after step 11.

25

Image 25

Contents Professional Puncher-A1 Table of Contents Introduction Professional PUNCHER-A1 FAQ’SIntroduction Die Sets X 11 LEF OnlyPunch Pattern Samples North America Letter Shown Unpacking InstallationUnit SET-UP Unit OperationFelt PAD Magnet Sheild Shoulder Bolt With Spring INSPECTION, Cleaning and Lubrication MaintenanceDIE SET Maintenance Setting the Right Expectations Preventative Maintenance ScheduleProduct Positioning DIE SET Position Cradle ADJUSTMENT, Centering Punched Holes Adjustment and Special ProceduresTool Recommendations Punched Hole Alignment Checking Turn Counter Clockwise Removal of Punch Module Symptom Green Belt REPLACEMENT, Aligner Panel REMOVAL, ExplanationPaper will stop moving through the Punch paper path CauseProcedure to Replace Aligner Belts Green Belt REPLACEMENT, Paper Entrance SideFC3-3633-0000 Binder Side Page Stretch Sensor Flexible Shaft Align & FIX Screws Instal J2 Shaft Green Belt REPLACEMENT, Paper Exit Side Binder Side Paper Enterance Aligner Drive Belt Assy Assembly Process Assemble Back Page General Description Installation StepsBack Gauge Assy Front Side To Clear a Paper JAM Software Update Procedure Version Tools Required Software Update Procedure VersionBootloaderg COM5 Theory of Operation Technical TroubleshootingInputs OutputsSerial Eeprom Control General TroubleshootingStepper #1 Control Punch ControlPage Symptom Probable Cause Corrective Action Troubleshooting Guide ChartPage OUBLRevHOOTING Guide Chart Punching Patterns Operating ControlsChanging the Punch DIE Sets Step Paper Chip DrawerProblem SOLVING, Operator Level Professional PUNCHER-A1 ServiceProblem Probable Cause SPECIFICATIONS, 208V & 230/240V Professional PUNCHER-A1 Specifications