Canon DU7-1175-000 service manual Sensor Flexible Shaft Align & FIX Screws

Page 19

Step 17: To install the Paper Guide Assembly into the Professional Puncher-A1.

1.As you slide the Paper Guide Assembly into place,

a.Hook up the Sensor Harness to the Sensor on the back.

b.Lift it up slightly to clear the lower Transition Paper Guide.

c.Be sure to clear the Sensor Bracket at the top left.

d.Be sure that the Flex Coupling Shaft is sticking out of the rear of the Professional Puncher-A1 properly.

2.Visually check all around the mounting area of the Paper Guide Assembly and that the Sensor Harness is properly connected.

3.Loosely secure it in place with “3” screws on the left and “3” on the right.

4.Loosely install the “2” top screws.

5.Once all “8” mounting screws have been properly started you have good alignment. You may now go back and tighten the screws until they are snug.

SENSOR

FLEXIBLE

SHAFT

ALIGN & FIX

SCREWS

Step 18: Install the Flexible Shaft (item 5).

Step 19: Install the curved sheet metal Exit Paper Guide (item 7) with Idler Roller “4” Screws.

Start all “4” screws, (2 on front and 2 on back) then tighten.

Step 20: Connect the Sensor Wire Harness at the top rear of the Exit Paper Guide.

19

Image 19
Contents Professional Puncher-A1 Table of Contents Introduction Professional PUNCHER-A1 FAQ’SIntroduction Die Sets X 11 LEF OnlyPunch Pattern Samples North America Letter Shown Unit Operation InstallationUnpacking Unit SET-UPFelt PAD Magnet Sheild Shoulder Bolt With Spring INSPECTION, Cleaning and Lubrication MaintenanceDIE SET Maintenance Setting the Right Expectations Preventative Maintenance ScheduleProduct Positioning DIE SET Position Cradle ADJUSTMENT, Centering Punched Holes Adjustment and Special ProceduresTool Recommendations Punched Hole Alignment Checking Turn Counter Clockwise Removal of Punch Module Cause Green Belt REPLACEMENT, Aligner Panel REMOVAL, ExplanationSymptom Paper will stop moving through the Punch paper pathProcedure to Replace Aligner Belts Green Belt REPLACEMENT, Paper Entrance SideFC3-3633-0000 Binder Side Page Stretch Sensor Flexible Shaft Align & FIX Screws Instal J2 Shaft Green Belt REPLACEMENT, Paper Exit Side Binder Side Paper Enterance Aligner Drive Belt Assy Assembly Process Assemble Back Page General Description Installation StepsBack Gauge Assy Front Side To Clear a Paper JAM Software Update Procedure Version Tools Required Software Update Procedure VersionBootloaderg COM5 Outputs Technical TroubleshootingTheory of Operation InputsPunch Control General TroubleshootingSerial Eeprom Control Stepper #1 ControlPage Symptom Probable Cause Corrective Action Troubleshooting Guide ChartPage OUBLRevHOOTING Guide Chart Punching Patterns Operating ControlsChanging the Punch DIE Sets Step Paper Chip DrawerProblem SOLVING, Operator Level Professional PUNCHER-A1 ServiceProblem Probable Cause SPECIFICATIONS, 208V & 230/240V Professional PUNCHER-A1 Specifications