5.TECHNICAL TROUBLESHOOTING
5.1THEORY OF OPERATION
The CANON Stream Punch is a machine that punches various die set hole patterns into single sheets of paper. The machine is placed between a printer / copier and a finisher. There are two paper paths. One is the bypass section, which does not punch paper. The other is the punch path. The punch path can be selected by pressing the green button on the top of the Stream Punch.
The Stream Punch consists of several input / output devices to operate the machine functions. The system intelligence is a Microchip
Refer to the electrical wiring information, when reading the following material.
INPUTS:
Sensor 1 | Optical | Starts machine motors, Sheet speed measurement, Jam detect |
Sensor 2 | Optical | Stepper 1 control, Sheet speed measurement, Jam detect |
Sensor 3 | Optical | Punch mechanism control, Backstop raiser, Jam detect |
Sensor 4 | Optical | Jam detect at entrance of |
Sensor 5 | Optical | Jam detect at exit of |
Sensor 6 | Optical | Stepper 2 Control, Jam detect |
Sensor 7 | Optical | Exit sensor, Jam detect |
Sensor 8 | Optical | Bypass sensor, Sheet speed measurement, Jam detect |
Sensor 9 | Optical Vane | Monitors rotation of punch mechanism, Controls clutch and brake |
Switch 1 | Keypad | Selects punch mode |
Switch 2A | Mechanical | Interlock Voltage, no machine movement if door is open |
Switch 2B | Mechanical | Door open signal |
Switch 3 | Mechanical | Chip tray switch |
Switch 4 | Mechanical | Die Set switch |
OUTPUTS:
Diverter | DC Solenoid | Diverts paper from bypass to punch sections |
Brake | DC Brake | Stops the punch mechanism, keeps it in correct position |
Clutch | DC Clutch | Clutches the punch mechanism to drive through paper |
Backstop | DC Solenoid | Provides stop for paper to rest against during punching |
Transport | AC Motor | Provides paper movement through machine |
Punch | AC Motor | Provides power to punch the paper |
Stepper 1 | PWM Signal | Controls Stepper Motor 1 |
| Winding | On / Off signal for stepper holding current |
Stepper 2 | PWM Signal | Controls Stepper Motor 2 |
| Winding | On / Off signal for stepper holding current |
PRINTER COMMUNICATION: | ||
|
|
|
Punch | Input | Printer turns on Punch enabled mode (not presently |
|
| operational) |
Motor | Input | Printer turns on Stream Punch Motor |
Jam | Output | Punch signals a jam or the door is open (no operation |
|
| allowed) |
Tray / | Output | Punch indicates tray or die set missing (bypass only |
Die |
| allowed) |
34