Canon DU7-1175-000 service manual Assemble Back

Page 26

As a double check, hold the entire Paper Guide assembly up so that you can visually inspect the alignment between the sheet metal surface and the metal surface of the Aligner. The Green Belt should appear to be even and just floating above the surface of the sheet metal.

ALIGN

& FIX SCREWS

Step 15: To install the Paper Guide Assembly into the Professional Puncher-A1.

ASSEMBLE BACK

A.As you slide the Paper Guide Assembly into place,

a.Hook up the Sensor Harness to the Sensor on the back.

b.Lift it up slightly to clear the lower Transition Paper Guide.

c.Be sure to clear the Sensor Bracket at the top left.

d.Be sure that the Flex Coupling Shaft is sticking out of the rear of the Professional Puncher-A1 properly.

B.Visually check all around the mounting area of the Paper Guide Assembly and that the Sensor Harness is properly connected.

C.Loosely secure it in place with “3” screws on the left and “3” on the right.

D.Loosely install the “2” top screws. A useful tip might be to secure the Screw to the tip of your Screwdriver with a small piece of masking tape to assist you in finding the hole.

26

Image 26

Contents Professional Puncher-A1 Table of Contents Introduction Professional PUNCHER-A1 FAQ’SIntroduction Punch Pattern Samples North America Letter Shown X 11 LEF OnlyDie Sets Unit SET-UP InstallationUnpacking Unit OperationFelt PAD Magnet Sheild Shoulder Bolt With Spring Maintenance INSPECTION, Cleaning and LubricationDIE SET Maintenance Product Positioning Preventative Maintenance ScheduleSetting the Right Expectations Tool Recommendations Adjustment and Special ProceduresDIE SET Position Cradle ADJUSTMENT, Centering Punched Holes Punched Hole Alignment Checking Turn Counter Clockwise Removal of Punch Module Paper will stop moving through the Punch paper path Green Belt REPLACEMENT, Aligner Panel REMOVAL, ExplanationSymptom CauseFC3-3633-0000 Green Belt REPLACEMENT, Paper Entrance SideProcedure to Replace Aligner Belts Binder Side Page Stretch Sensor Flexible Shaft Align & FIX Screws Instal J2 Shaft Green Belt REPLACEMENT, Paper Exit Side Binder Side Paper Enterance Aligner Drive Belt Assy Assembly Process Assemble Back Page Installation Steps General DescriptionBack Gauge Assy Front Side To Clear a Paper JAM Software Update Procedure Version Software Update Procedure Version Tools RequiredBootloaderg COM5 Inputs Technical TroubleshootingTheory of Operation OutputsStepper #1 Control General TroubleshootingSerial Eeprom Control Punch ControlPage Troubleshooting Guide Chart Symptom Probable Cause Corrective ActionPage OUBLRevHOOTING Guide Chart Changing the Punch DIE Sets Operating ControlsPunching Patterns Paper Chip Drawer StepProblem Probable Cause ServiceProblem SOLVING, Operator Level Professional PUNCHER-A1 Specifications SPECIFICATIONS, 208V & 230/240V Professional PUNCHER-A1