Canon DU7-1175-000 service manual Installation, Unpacking, Unit SET-UP, Unit Operation

Page 5

2.INSTALLATION

2.1UNPACKING

UNPACKING

•Inspect the outside of the package for shipping damage. If there is evidence of shipping damage, contact the shipping carrier immediately.

•Remove the punch from its shipping carton.

•Inspect for any concealed damage to unit. If there is evidence of concealed shipping damage, contact the shipping carrier immediately.

•Remove all shipping tape from doors and levers.

2.2UNIT SET-UP

Step One: Connect the communication cable.

Step Two: Connect the power cord.

2.3UNIT OPERATION

•Check to ensure that the paper chip tray is securely in place.

•Check to ensure that a Die Set is installed properly and that any extra Die Sets are securely stored in the Die Storage Area.

•Run a small test job in “Bypass” mode. Check to ensure that the job is not punched and bypasses properly.

•Run a small job with Punch Enabled. Check the punched holes of the job.

5

Image 5

Contents Professional Puncher-A1 Table of Contents Introduction Professional PUNCHER-A1 FAQ’SIntroduction Punch Pattern Samples North America Letter Shown X 11 LEF OnlyDie Sets Unpacking InstallationUnit SET-UP Unit OperationFelt PAD Magnet Sheild Shoulder Bolt With Spring INSPECTION, Cleaning and Lubrication MaintenanceDIE SET Maintenance Product Positioning Preventative Maintenance ScheduleSetting the Right Expectations Tool Recommendations Adjustment and Special ProceduresDIE SET Position Cradle ADJUSTMENT, Centering Punched Holes Punched Hole Alignment Checking Turn Counter Clockwise Removal of Punch Module Symptom Green Belt REPLACEMENT, Aligner Panel REMOVAL, ExplanationPaper will stop moving through the Punch paper path CauseFC3-3633-0000 Green Belt REPLACEMENT, Paper Entrance SideProcedure to Replace Aligner Belts Binder Side Page Stretch Sensor Flexible Shaft Align & FIX Screws Instal J2 Shaft Green Belt REPLACEMENT, Paper Exit Side Binder Side Paper Enterance Aligner Drive Belt Assy Assembly Process Assemble Back Page General Description Installation StepsBack Gauge Assy Front Side To Clear a Paper JAM Software Update Procedure Version Tools Required Software Update Procedure VersionBootloaderg COM5 Theory of Operation Technical TroubleshootingInputs OutputsSerial Eeprom Control General TroubleshootingStepper #1 Control Punch ControlPage Symptom Probable Cause Corrective Action Troubleshooting Guide ChartPage OUBLRevHOOTING Guide Chart Changing the Punch DIE Sets Operating ControlsPunching Patterns Step Paper Chip DrawerProblem Probable Cause ServiceProblem SOLVING, Operator Level Professional PUNCHER-A1 SPECIFICATIONS, 208V & 230/240V Professional PUNCHER-A1 Specifications