2Adjust the manual feeder guides to the width of the print material without bending it.
3After loading paper, you need to set the paper type and size for the manual feeder. See page 3.6 for copying or the Software Section for
NOTE: The settings made from the printer driver override the settings on the control panel.
4If you want to use the rear cover, open the rear cover.
Tips on using the manual feeder
•Print materials should be loaded face up with the top edge going into the manual feeder first and be placed in the center of the tray.
•Always load only the print materials specified in the Specifications on page 3.2 to avoid paper jams and print quality problems.
•When you print on 76 x 127 mm (3 x 5 inches) sized media on the manual feeder, open the rear cover to use the rear cover.
•Make sure to open the rear cover when you print on transparencies. If not, they may tear while exiting the machine.
4Press the scroll button (
or 
) to find the paper size you are using and press OK.
5Press Back to return to the upper level.
6Press the scroll button (
or 
) to select Paper Type and press OK.
7Press the scroll button (
or 
) to find the paper type you are using and press OK.
8Press Stop/Clear to return to Standby mode.
Selecting an output location
The machine has two output locations: the rear cover (face up) and the output tray (face down).
To use the output tray, make sure that the rear cover is closed. To use the rear cover, open the rear cover.
NOTES:
•If paper coming out of the output tray has problems, such as excessive curl, try printing to the rear cover.
•To avoid paper jams, do not open or close the rear cover while the machine is printing.
Printing to the output tray (Face down)
The output tray collects printed paper face down, in the order in which the sheets were printed. The tray should be used for most print jobs.
If you use paper which is not long enough to reach the output tray, use the scan unit.
To use the scan unit:
1Lift the scan unit. A tab automatically springs up to support the cover.
Setting the paper size and type
After loading paper in the paper tray, you need to set the paper size and type using the control panel buttons. These settings will apply to Copy mode. For
1Press Menu until Paper Setting appears on the top line
of the display.
2Press OK when Paper Size appears.
3Press the scroll button (
or 
) to select the paper tray you want to use and press OK.
3.6
Loading original documents and paper