JVC VR-510U manual Preparation, Installing a battery, Power supply

4 PREPARATION

4-1 Installing a battery

		DIGITAL VIDEO RECORDER VR-510U
POWER	TIMER CANCEL MENU	L
		SE ECT

				REV	FWD	REC
	WARNING
			DISPLAY	SEARCH		CLOCK RESET/ CLEAR
					EXECUTE	OPE. LOCK
SLEEP	REC	STOP	PLAY	STILL
						ON
					SKIP/ALARM
					SEARCH

2.

3.

1.Turn the [POWER] switch OFF.

2.Open the battery cover.

While pushing down the pawl in the upper section of the battery cover, pull it towards you to open the cover.

3.Install a battery.

Install the provided battery (CR2032) with the + side facing you.

4.Close the battery cover.

Close it until the pawl is locked firmly.

Caution:

●When the power is supplied, do not replace the battery. Otherwise, a malfunction may occur.

●Replace the battery with a CR2032 type battery. Using any other type of battery may present a risk of fire or explosion.

Memo:

●When you replace the battery, be sure to set the date and time again.

Reference: “4-3 Setting the date and time” on page 13.

●After replacing the battery, be sure to program the program timer again because the programs are reset.

●When “LOW BATTERY” is displayed, check the battery again.

4-2 Power supply

CAMERA IN

1

1 2

MONITOR OUT

[POWER] switch 1. Connect the power cable.

Connect the provided power cable to an AC 120 V outlet.

					POWER		2. Press the [POWER] switch to ON.
AUDIO		RS-232C		ON	I O	OFF
IN							The system check starts for this unit and “SYSTEM
1							LOADING ...” is displayed on the monitor.
2	COM SPARE SPARE COM RESET OUT FULL OUT
	CAM SW ALARM	ALARM CLOCK EXT
	OUT IN1	SPARE RESET RESET IN REC IN
		CLOCK	HDD
			SIGNAL GND		AC IN 120 V
					50 Hz / 60 Hz		“LoAd--” blinks on the display panel.
AUDIO
OUT

[AC IN] socket VN

S

Caution:

●After all other equipment connections are complete, turn the power of this unit ON.

Memo:

●All operation functions are disabled during system check. Wait until “SYSTEM LOADING ...” goes out.

12