JVC VR-510U manual Safety Precautions, Information

Page 3

SAFETY PRECAUTIONS

CAUTION

RISK OF ELECTRIC SHOCK

DO NOT OPEN

CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK).

NO USER-SERVICEABLE PARTS INSIDE.

REFER SERVICING TO QUALIFIED SERVICE PERSONNEL

The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated “dangerous voltage” within the product’s enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons.

The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance.

ATTENTION

RISQUE D’ELECTROCUTION

NE PAS OUVRIR

ATTENTION: POUR EVITER TOUT RISQUE D’ELECTROCUTION NE PAS OUVRIR LE BOITER.

AUCUNE PIECE INTERIEURE N’EST

A REGLER PAR L’UTILISATEUR.

SE REFERER A UN AGENT QUALIFIE EN CAS DE PROBLEME.

Le symbole de l’éclair à l’intérieur d’un triangle équilatéral est destiné à alerter l’utilisateur sur la présence d’une “tension dangereuse” non isolée dans le boîtier du produit. Cette tension est suffisante pour provoquer l’électrocution de personnes.

Le point d’exclamation à l’intérieur d’un triangle équilatéral est destiné à alerter l’utilisateur sur la présence d’opérations d’entretien importantes au sujet desquelles des renseignements se trouvent dans le manuel d’instructions.

*Ces symboles ne sont utilisés qu’aux Etats-Unis.

WARNING:

TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.

This unit should be used with 120 V AC only.

CAUTION:

To prevent electric shocks and fire hazards, DO NOT use any other power source.

NOTE:

The rating plate (serial number plate) is on the bottom of the unit.

INFORMATION

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installa- tion. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interfer- ence will not occur in a particular installation.

If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

Consult the dealer or an experienced radio/TV technician for help.

CAUTION

CHANGES OR MODIFICATIONS NOT APPROVED BY JVC COULD VOID USER’S AUTHORITY TO OPERATE THE EQUIPMENT.

THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS: (1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND (2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED OPERA- TION.

AVERTISSEMENT:

POUR EVITER LES RISQUES D’INCENDIE OU D’ELECTROCUTION, NE PAS EXPOSER L’APPAREIL A L’HUMIDITE OU A LA PLUIE.

Ce magnétoscope ne doit être utilisé que sur du courant alternatif en 120 V.

ATTENTION:

Afin d’éviter tout resque d’incendie ou d’électrocution, ne pas utiliser d’autres sources d’alimentation électrique.

REMARQUE:

La plaque d’identification (numéro de série) se trouve sur le panneau arrière de l’appareil.

WARNING ON LITHIUM BATTERY

The battery used in this device may present a fire or chemical burn hazard if mistreated. Do not recharge, disassemble, heat above 100˚C (212˚F) or incinerate.

Replace battery with Matsushita Electric CR2032, use of another battery may present a risk of fire or explosion.

Dispose of used battery promptly.

Keep away from children.

Do not disassemble and do not dispose of in fire.

INFORMATION (FOR CANADA)

RENSEIGNEMENT (POUR CANADA)

This Class B digital apparatus complies with Canadian ICES- 003.

Cet appareil numérique de la Class B est conforme à la norme NMB-003 du Canada.

3

Image 3
Contents For Customer Use VR-510USerial No Page Information Safety PrecautionsContents Major features PrecautionsIntroduction Front panel CONTROLS, Connections and DisplayRear panel Display Connections Recording video signals from a cameraConnecting a camera Menu switch settingMonitor Connecting more than one camera using an external switcherConnection procedures Power cableConnecting signal input/output terminals Installing a battery Power supplyPreparation Setting the date and time Daylight-saving compensationDuring daylight-saving time Standard time On-screen display ON-SCREEN DISPLAY/MENU SwitchesMenu switches Menu flowMain menu screen Jog dial operation Menu switches contdJog/shuttle dial operation Shuttle dial operationDisplay  Set REC Quality and REC Speed on the display panel SettingMenu switch details Setting in is the factory settingSetting item Menu switch Setting value Description Menu switch details contd ALARM/SENSOR OFF Alarm REC Mode OFFSensor Mode Alarm OFF Sensor AlarmRecording system Major menu switchesRecording Basic operationWeekly timer Program timer recordingTimer-recording for 24 hours or more Program timer recording contdMove the cursor Daily timerCanceling a timer recording program Operation in the Timer Recording Standby modeChanging timer program settings Holiday timer recording Connect an alarm sensor Alarm recordingRepeat recording during alarm recording Cancel button Jog dialExample Pre-sensor recordingOperation Recording with an external activation signalAutomatic restart of recording after power failure ConnectionPlayback Simultaneous Playback modeJog/shuttle playback Shuttle playback operationJog playback operation Execute time search Skip searchTime search About the time searchEvent search Alarm searchAbout event/alarm search Skip search contdDay/time direct search Alarm or day/time direct searchAlarm direct search  Clearing the alarm listScanning the disk Hard disk maintenance Scan the disk when the power is on Hard Disk ControlErase & format the disk Hard disk maintenance contdErasing & formatting  Erasing & formattingIndication lights TroubleshootingError indication On-screen indication Cause Possible solutionNo error indication  Basic table SpecificationsProtocols and commands 10 RS-232C Interface JVC table Protocols and commands contd Preparation Commands Operation commands Commands DescriptionCommands contd  Setup commandsBit Playback Camera Fixed Command Description  Sense commandsB9H BEH Recording time OthersClock Reset Signal input/output terminalsTerminals Signal level Remarks Clock Reset OUTAudio signal system Provided accessoriesVideo signal system DimensionsPage Page VR-510U Digital Video Recorder