Concerning the Internal Hard Disk Drive
The internal hard disk drive (HDD) is a fragile piece of equipment. Please follow the guidelines below when using the DVR to protect against possible HDD failure.
We recommend that you back up your important recordings onto an external backup device in order to prevent accidental loss.
Make sure that the power is turned OFF when attach- ing or removing the HDD.
•Do not move the DVR while the power is on.
•Do not block the rear vent/cooling fan.
•Do not use the DVR in excessively hot or humid places, or in places that may be subject to sudden changes in temperature. Sudden changes in tem- perature can cause condensation to form inside the DVR. This can be a cause of HDD failure.
•While the DVR is switched on, do not unplug from the wall socket or switch the electricity off from the breaker switch.
•If there’s a power failure while the DVR is on there is a chance that some data on the HDD will be lost.
•Do not drop the HDD. Also do not put the metallic object such as coins or screwdrivers into the HDD tray.
•When a power failure occurs during recording, avoid adding, replacing or transporting the HDD as the recorded data may be erased. In this case, turn the power back on to boot up the unit normally with the HDD that was being used at the time of the power failure attached. Then add, replace, or trans- port the HDD.
•The HDD is very delicate. Handle the HDD with care and follow the precautions below because even a small shock may damage the internal com- ponents of the HDD.
-Do not place the HDD on a desk or a table directly. Put a thick cushion under the HDD because even a small shock may damage the internal components of the HDD.
-Do not use an electric screwdriver. Vibrations and shocks caused by an electric screwdriver may damage the internal components of the HDD.
-When replacing the HDD, do not knock the HDD with other components such as another HDD and the HDD tray.
-Do not knock the HDD with tools such as a driver when replacing the HDD.
•Protect the hard disk drives from static electricity.
Installing or Replacing the Hard Disk Drive
Installing the Hard Disk Drive
You can install up to 4 HDDs.
However, since the product contains many parts which may incur electric shocks, accidents or product breakdown, and because improper instal- lation or setup may disturb HDD recognition or normal product operation, you should consult with an expert from the store where the product was purchased.
Turn the power of the unit off and detach the power plug from the outlet.
1.Remove the fixing screws on the left/right side and rear panel.
2.Detach the top case by sliding it after removing the screws.
3. Detach the front panel as shown below.
HOOKUP AND SETTINGS
15