LG Electronics LDV-S503, LDV-S504 Before Operating the System, The following HDD has been, HDDs

5.Remove the HDD from the hard disk mounting bracket.

6.Install the new HDD in the reverse order to when replacing the hard disk drive.

7.After replacing the hard disk drive, insert the power plug into the outlet and turn the power of the unit on.

Notes:

•When you install or replace the HDDs to the hard disk mounting bracket, you must set the HDD jumper to slave or master.

You must install the HDD as shown below.

-Upper sides: Set the master HDD.

-Lower sides: Set the slave HDD.

•How and where to set the HDD jumper depends on the manufacturer or model specification. Therefore, carefully read the instructions printed on top of the product or in the manual enclosed with the product before installing the jumper.

-If the jumper pin settings are identical with each other in terms of priority, either HDD may not be detected in the DVR or malfunction may occur.

•Make sure that each of the IDE cables is connect- ed to the connector housing through its holes.

•Do not stack them nor keep them upright.

•Do not use an electric screwdriver to fix them.

Before Operating the System

You can select the main monitor type to display the main screen.

1.Insert the power plug to an outlet.

(Make sure the power source is AC 100~240V, 50/60Hz)

2.Turn on the main power switch on the rear panel. The power indicator LED on the front panel will show a red light.

3.Select monitor type.

VGA Monitor:

When you connect the VGA jack on the rear of the DVR, press and hold the MAIN button on the front panel until the beep sounds to display the main screen.

CCTV (Composite Video Type) Monitor: When you connect the MAIN-OUT or S-VIDEO jack on the rear of the DVR, press and hold the SPOT button on the front panel until the beep sounds to display the main screen.

Note:

You can select the monitor type by using the MAIN or SPOT button at anytime. If you change the monitor type, the system will be rebooted automatically.

4. Turn on the sub-power.

HOOKUP AND SETTINGS

	Maker	RPM	Capacity	Interface	Model No.
Recommended HDD
		7,200	80 GB		HDS728080PLAT20
The following HDD has been		7,200	160 GB	Ultra	HDT722516DLAT80
	Hitachi
		7,200	250 GB		HDT722525DLAT80
				ATA133
tested and compatibility is		7,200	320 GB		HDT725032VLAT80
ensured. When you attach multi-		7,200	500 GB		HDT725050VLAT80
ple HDDs use the recommended		7,200	200 GB		ST3200827ACE
HDDs.	Seagate	7,200	250 GB	Ultra	ST3250824ACE
		7,200	300 GB		ST3300822ACE
				ATA100
		7,200	500 GB		ST3500841ACE

19