Honeywell HRDE4X4 Connecting Peripheral Equipment, Rear Panel Connections Connector Description

Figure 2-1 NTSC/PAL Operation Switch

CH3 PAL: CH4Set to ON position

VIDEO OUT

RS-232	P V
	A G
	L	A
	ON 1 2
VGA		DC 12V

Connecting Peripheral Equipment

Figure 2-2shows the rear panel connections. Refer to Table 2-1to connect your network system components.

Figure 2-2 Rear Panel Connections

CAUTION			AUDIO IN				VIDEO IN
RISK OF ELECTRIC SHOCK	RS-422/485
DO NOT OPEN		CH1	CH2	CH3	CH4	CH1	CH2
WARNING	TX+ TX- RX+ RX-

TO REDUCETHE RISK OF FIRE OR ELECTRIC

SHOCK DOOTN EXPOSETHIS APPLIANCETO

RAIN OR MOISTURE

CAUTION
TO REDUCETHE RISK OF ELECTRIC SHOCK								RS-232
NO USER SERVICEABLEPARTS INSIDE.REFER	1 G 2 G 3	G 4 G	OUT
SERVICINGTO QUALIFIED SERVICE PERSONNEL
								ON
ETHERNET	SENSOR		ALARM	AUDIO OUT	CH3	CH4	VIDEO OUT	VGA

PV A G L A

1 2

DC 12V

Table 2-1describes the rear panel connections as shown in Figure 2-2from left to right.

Table 2-1 Rear Panel Connections

Connector Description

RS-422/485Remote camera control (see Controlling a PTZ Camera, page 21).

ETHERNET Network the DVR using 10/100 MB Ethernet connector. Network to a PC for remote monitoring and searching (see Setting Network Parameters, page 21).

AUDIO IN Connect to a pre-amplified line level audio source, such as a microphone.

Note It is the user’s responsibility to determine if the local laws and regulations permit recording audio.

AUDIO OUT Connect to an amplifier.

Rev 2.00	7	Document 900.0399
		03/06