Honeywell HRDE4X4 manual Alarm, Out, Video OUT, Vga, Switches

Table 2-1 Rear Panel Connections (Cont’d)

Connector Description

SENSOR IN Connect to external alarm sensor devices to signal the DVR to react to events. Four sensors can be connected to the equipment sensor 1–4 dedicated to Video channel 1–4 respectively. Simple On/Off switching of sensor inputs 1–4, normal open (NO) and ground connected to input starts recording or normal close (NC) and ground connected to input stops recording (see Recording Mode, page 15 to program sensor recording).

Connect two wires to operate a sensor input correctly to the Terminal block on the rear panel of the HRDE4X4. One ground wire between the external device and to the HRDE4X4 ensures the ground reference voltage is identical. This line connects to the terminal block G input. Connect the other wire to be used to trigger the record condition to the sensor input 1–4connection on the terminal block.

Sensor Input	1 G 2 G 3 G 4 G	OUT
Connections

In 1

In 2

In 3

In 4

ALARM

	GND 1 GND 2 GND 3	GND 4
ALARM	Connect to an external alarm device. On/off switching using an internal
OUT	relay, 0.5A/125V, 1A/30V. The relay is open when not triggered. The relay
	can be triggered to close by either motion or a sensor input, if enabled in
	the Recording Setup menu.
VIDEO IN	Connect NTSC or PAL camera coaxial outputs (up to 4) to the BNC Video
	In connectors.
	Caution Do not mix NTSC and PAL cameras.
VIDEO OUT	Connect to a monitor.
RS-232	For engineering use only.
VGA	Connect to a VGA monitor.
	Note When using a VGA monitor, make sure you set the VGA switch to
	ON and power reset the unit (turn unit off then on).
SWITCHES
PAL	Set to the ON position when PAL cameras are connected.
	Note When you change the position of the PAL switch, reboot the DVR
	to apply the new setting.
VGA	Set to the ON position when a VGA monitor is connected.
	Note When you change the position of the VGA switch, reboot the DVR
	to apply the new setting. When VGA is enabled, the video out
	connector (composite) is disabled. Also when the Video Out is
	enabled, the VGA is disabled.
DC 12V	Apply 12 VDC using the DC switching adapter supplied.
Rev 2.00	8	Document 900.0399
		03/06