Honeywell HRDE4X4 manual Typical DVR Installation, Setting Unit for Ntsc or PAL

Page 14

Typical DVR Installation

Four Video Inputs for Cameras

Four Audio

Inputs

RS-232 for

Engineering Use

LAN for Remote Access Software Connection

1 Internal Alarm

Output Relay

	Four Sensor	Audio Line
	Inputs	Audio Line
	Inputs	Output
		Output
		CCTV Monitor

To 12 VDC

Adapter

VGA Monitor

Setting Unit for NTSC or PAL

Before turning on your DVR, set the switch (see Figure 2-1) to NTSC or PAL to match your equipment. If your DVR is already powered, unplug the power cord from the wall outlet. Wait a few seconds, set the switch (see Figure 2-1), and then re-apply power.

Note You cannot mix NTSC and PAL equipment. For example, do not connect NTSC cameras when your DVR is set to PAL. Similarly, do not connect a PAL camera and an NTSC monitor.

Rev 2.00	6	Document 900.0399
		03/06

Image 14

Contents HRDE4X4 Digital Video Recorder User GuideIssue Date Revisions RevisionsFCC Compliance Statement Weee Waste Electrical and Electronic Equipment Contents Appendix D Specifications RAS ConfigurationAppendix a DVR Firmware Upgrade Figures Figure A-1 Engineering Mode Technical Overview FeaturesIntroduction Important Safeguards Dispose of used batteries according to the instructions Page Unpack Everything DVR Unit InstallationBefore You Begin Typical DVR Installation Setting Unit for Ntsc or PALConnecting Peripheral Equipment Rear Panel Connections Connector DescriptionOUT AlarmSwitches VideoConnecting the Power Cord Rev Document 03/06 DVR Configuration Front Panel LEDs and ControlsUSB Port Initial Setup Menu StructureLive Mode Recording Mode Motion Zones Motion Zone Setup Screen Recording SchedulesSetting System Parameters Date Format AdminPassword SET Date & TimeDVR ID Setup Screen Setting Network Parameters Controlling a PTZ CameraBandwidth Remote AccessPort SavingName Send E-MAIL Network Setup Fields Cont’dDdns Server Mail AddressStorage Setup DhcpFormat Storage Setup Fields DescriptionOverwrite Saving Setup 14 Save Setup ScreenFront Panel Operation Live Viewing WindowButton Description Search WindowButton Functions in Live Viewing Window Event Search Event Search ScreenTime-Line Search Event Search List ScreenGo To Search Time-line Search ScreenLog List Search Go First SearchGo Last Search Archive Search 10 Archive Search ScreenPlay Mode Press to launch the archiving function Network ModeHighlighted channel Transferring Still Images or Video onto USB Archiving VideoArchiving Images or Video onto the Hard Drive 15 Archive Menu Screen Rev Document 03/06 Minimum PC Requirements RAS InstallationInstalling the RAS Program Choose Destination Location Live Viewing Interface RAS OperationLive Viewing Live Viewing Interface Controls Live Viewing Interface Controls Cont’d Interface Control Description Search and Playback ViewingSearch and Playback Interface Search and Playback Interface Controls Search and Playback Interface Controls Cont’d Back Up a Video Clip in AVI Format Main User Interface with Back Up Times MarkedAVI Backup Window RAS Configuration General SetupSite Setup Event SetupEvent Search Setup Event Search MenuRecord Menu Settings Setting Operation Record MenuDisk Menu Video MenuAbout Menu Start Engineering Mode DVR Firmware UpgradeCopy Firmware Upgrade to USB Stick Upgrading Using USB Stick Verifying Software InstallationFigure B-1 Ffdshow Video Decoder Configuration Playing AVI Archive ClipsRev Document 03/06 Remote Control Operation Optional ItemsConfiguring Multiple Units for Remote Control Press to select the remote unitConnectors SpecificationsTable D-1 Technical Specifications Video Inputs, OutputsGeneral Table D-1 Technical Specifications Cont’dStorage Page Video Systems