Honeywell HRDE4X4 manual Controlling a PTZ Camera, Setting Network Parameters

Controlling a PTZ Camera

To control the PTZ functions of the camera, connect the controller to the RS485 port on the rear panel (see Figure 2-2).

Note For speed dome cameras that support RS485, connect them directly to the RS485 port.

If the camera is controlled with RS232C, use an RS485 to RS232C signal converter.

On the PTZ Control Setup screen (see Figure 3-11) you can select or set the protocol type of the camera that is the same as the one installed on the site. If the camera has a specific camera ID, select the camera ID using the LEFT and RIGHT arrow controls. The following options are available on the PTZ CONTROL screen:

•CAMERA SPEED (19200, 14400, 9600, 4800, 2400)

•CAMERA NUMBER (channel number that the PTZ is connected to)

•CAMERA TYPE (protocol type)

•CAMERA ID (0–63)

Figure 3-11 PTZ Control Setup Screen

Setting Network Parameters

Set up your network parameters (for remote connection through the Remote Access Software) on the Network Setup screen. See Chapter 5, Chapter 6, and Chapter 7 for more information about RAS.

Rev 2.00	21	Document 900.0399
		03/06