Magnavox 22MF339B, 19MF339B Watching TV, 5Channel Selection, 5Volume Adjustment, 5Sleep Timer

WATCHING TV

5Channel Selection

Select channels by using [CH + / -] or [the Number buttons].

•To select the memorized channels, use [CH + / -]or [the Number buttons].

•To select the non-memorized channels, use [the Number buttons].

To Use [the Number buttons]

TV

- When selecting analog channel 11

DTV

-When selecting digital channel 11.1 Be sure to press [•] before entering the subchannel number.

•Press [PREV CH] to return to the previously viewed channel.

About digital TV broadcasting:

With its high definition broadcast, digital broadcasting far surpasses analog broadcasting in both its picture and sound quality. Not all digital TV broadcasts are high definition (HD). To confirm whether your watching TV program is in HD, refer to the program guide, contact your cable / satellite provider or local TV stations.

This section describes how to adjust the volume. The mute function, which		INTRODUCTION
5Volume Adjustment
turns the sound off and on, is also described.
		PREPARATION
Use [VOL + / -]to adjust the audio volume.
	Volume 30
The volume bar will be displayed at the bottom of the		WATCHING
TV screen when adjusting the volume.
• The volume bar will automatically disappear in a few		TV
seconds.

Press [MUTE] to turn off and on the sound.

		OPTIONAL
	Mute
“Mute” is displayed on the TV screen for a few seconds.		SETTING
Press [MUTE] again or [VOL + / -]to recover the
original volume.
		TROUBLESHOOTING
5Sleep Timer
The sleep timer can be set to automatically turn off the unit after an
incremental period of time.

NTSC

(analog mode)

CH4 (Soccer)

CH4 (Soccer)

CH4 (Soccer)

CH4 (Soccer)

Air time		ATSC
18:00		(digital mode)
		CH4-1(Soccer)
18:30		main channel
	CH4-1(Soccer)	CH4-2 (News)		CH4-3(Tennis)
19:00	main channel	subchannel		subchannel
		CH4-1(Soccer)
19:30		main channel
	CH4-1(Soccer)		CH4-2 (News)
20:00	main channel		subchannel
	can be changed by using [CH + / -].

1Press [SLEEP] to set the sleep timer.

			INFORMATION
	Sleep	Off
Sleep timer display appears on the TV screen.

2Press [SLEEP] repeatedly to change the amount of time until shut off.

Sleep 120min.

You can set your unit to turn off after a set period of time (from 30 to 120 minutes).

What is the subchannel?

By using high compression technology, digital broadcasting offers a service that enables multiple signals to send simultaneously.

Therefore, you can select more than one program per main channel since digital broadcasting technology distinguishes between multiple channels broadcast by a single network.

Note:

•“No Signal” will appear on the TV screen after the subchannel broadcast is over.

•“Audio only program“ message will appear on the TV screen, when you receive only sound signal.

•Each press of [SLEEP] will increase the time by 30 minutes.

•After setup, the sleep timer display can be called up for checking by pressing [SLEEP].

To cancel the sleep timer

Press [SLEEP] repeatedly until “Sleep Off” is displayed on the TV screen.

Note:

•The sleep timer display will automatically disappear in a few seconds.

•When you disconnect the unit from the AC outlet or when a power failure occurs, the sleep timer setting will be canceled.

15

EN