Runco XP-65DHD manual Value Description Min/max Stored? Power On/Off Commands

Serial Communications

Table 6-1lists the RS-232 command set. The “Parameter (min/max)” column shows the valid parameter ranges, or “NA” for commands that take no parameters.

When you enter a valid command, the DHD Controller executes it and acknowledges it with a plus sign on the command line (+ >). When you enter an invalid command – one that is misspelled or followed by values outside the valid range for that command – the DHD Controller ignores it and returns a minus sign (- >).

Table 6-1. Serial Commands

Command	Parameter		Value	Description
	(min/max)		Stored?
		Power On/Off Commands
OFF	NA		NA	Turns system off
ON	NA		NA	Turns system on
POWER	0/1		NA	Turns system on or off (toggles on/off state)
POWER?	NA		NA	Returns power status
	Input Selection Commands
COMPONENT	NA		YES	Selects the Component input
COMPOSITE	NA		YES	Selects the Composite video input
HDMI1	NA		YES	Selects the HDMI 1 input
HDMI2	NA		YES	Selects the HDMI 2 input
HD1	NA		YES	Selects the RGB HD 1 input
HD2	NA		YES	Selects the RGB HD 2 input
INPUT?	NA		NA	Returns active input
SVIDEO1	NA		YES	Selects the S-Video 1 input
SVIDEO2	NA		YES	Selects the S-Video 2 input
Aspect Ratio Commands (not available on HDMI 1 or HDMI 2 inputs)
16:9	NA		YES	Selects the 16:9 aspect ratio
ASPECT?	NA		NA	Returns current aspect ratio
CINEMA	NA		YES	Selects the Cinema aspect ratio
LETTERBOX	NA		YES	Selects the Letterbox aspect ratio
4:3	NA		YES	Selects the 4:3 aspect ratio
VIRTUALWIDE	NA		YES	Selects the VirtualWide aspect ratio

56 PlasmaWall XP Series Owner’s Operating Manual