Sanyo PLC-XP57L owner manual Video Input, When Selecting Input 3 AV Terminals

VIDEO INPUT

SELECTING INPUT SOURCE

DIRECT OPERATION

Select an INPUT source by pressing the INPUT button on the top control or the INPUT 1, INPUT 2, or INPUT 3 buttons on the remote control.

If the projector cannot reproduce proper image, select a correct input source with the MENU OPERATION (see below).

MENU OPERATION

INPUT button

Input 1

Input 2

Input 3

✽Input 1 is not displayed when the Input 1 is used as Monitor out.

WHEN SELECTING INPUT 2 (5 BNC INPUT JACKS )

When connecting to video equipment, select a type of Video

source in the Source Select Menu.

INPUT MENU

1	Press the MENU button to display the On-Screen Menu.
	Press the POINT LEFT/RIGHT buttons to move the red frame
	pointer to the INPUT Menu icon.
2	Press the POINT UP/DOWN buttons to move the red arrow
	pointer to Input 2 and then press the SELECT button. A

Source Select Menu appears.

INPUT Menu icon

Move the pointer (red arrow) to Input 2 and press the SELECT button.

3	Move the pointer to a source that you want to select and then		Input 2
	press the SELECT button.
		When the video input signal is connected to the
	Video
		VIDEO jack, select Video.
		When the video input signal is connected to the Y-
Y, Pb/Cb, Pr/Cr
		Pb/Cb-Pr/Cr jacks, select Y, Pb/Cb, Pr/Cr.

NOTE:

•INPUT SOURCE changes if the INPUT 2 button on the remote control is pressed.

Source Select Menu

Move the pointer (red arrow) to Video or Y, Pb/Cb, Pr/Cr and press the SELECT button.

WHEN SELECTING INPUT 3 (AV TERMINALS )

When connecting to video equipment, select a type of Video source in the Source Select (Video) Menu.

1	Press the MENU button to display the On-Screen Menu.
	Press the POINT LEFT/RIGHT buttons to move the red frame
	pointer to the INPUT Menu icon.
2	Press the POINT UP/DOWN buttons to move the red arrow
	pointer to Input 3 and then press the SELECT button. A
	Source Select Menu appears.
3	Move the pointer to a source that you want to select and then
	press the SELECT button.
		When the video input signal is connected to the
	Video
		VIDEO jack, select Video.
		When the video input signal is connected to the Y-
Y, Pb/Cb, Pr/Cr
		Pb/Cb-Pr/Cr jacks, select Y, Pb/Cb, Pr/Cr.
		When the video input signal is connected to the S-
S-Video
		VIDEO jack, select S-Video.

NOTE:

•INPUT SOURCE changes if the INPUT 3 button on the remote control is pressed.

INPUT MENU

INPUT Menu icon

Move the pointer (red arrow) to Input 3 and press the SELECT button.

Input 3

Source Select Menu

Move the pointer (red arrow) to a source and press the SELECT button.

31