SETTING
Logo
This function allows you to customize the screen logo with Logo select, Capture, and Logo PIN code lock functions.
Logo select
This function decides the
Default . the
Capture
This function enables you to capture the image being projected and use it for a
After capturing the projected image, go to the Logo select function and set it to “User.” Then the captured image will be displayed when turning on the projector the next time.
To capture the image, select [Yes]. To cancel the Capture function, select [No].
NOTE:
•Before capturing an image, select Standard in the IMAGE SELECT Menu to capture proper image. (See pages 29, 33.)
•A signal from a computer can be captured up to XGA (1024 X 768).
•Certain signals may not be captured properly.
•When capturing the image that has been adjusted by the Keystone function, the adjusted data is automatically reset and the projector captures an image without keystone correction.
•When starting to capture a new image, the previously stored image is cleared even if you cancel the capturing.
•Once you exit the Logo Menu after setting the Logo lock to "On," you are required to enter the PIN code every attempting to change the Logo setting.
Logo PIN code lock
This function prevents an unauthorized person from changing the Logo setting.
Off . . . . the Logo setting can be changed freely from the Logo function.
On . . . . the Logo setting cannot be changed without a Logo PIN code.
If you want to change the Logo PIN code lock setting, enter a Logo PIN code by following the steps below. The initial Logo PIN code is set to “4321” at the factory.
To Enter a Logo PIN code
Select a number by pressing the POINT LEFT/RIGHT buttons and fix the number with the SELECT button. The number changes to “✳.” If you fixed a wrong number, move the pointer to “Set” or “Clear” once by pressing the POINT DOWN button, then return to “Logo PIN code.” Enter the correct number.
Repeat this step to complete entering a
When the
If you entered a wrong Logo PIN code, “Logo PIN code” and the number (✳✳✳✳) turn red and disappear. Enter a Logo PIN code all over again.
Logo
Select [Yes] to capture the projected image.
Select [Yes] to stop capturing.
Logo PIN Code Lock Dialog Box
Pointer
Quit
After a correct Logo PIN code is entered, the following dialog box appears.
Select On/Off by pressing the POINT LEFT/RIGHT buttons or change the Logo PIN code.
To Change the Logo PIN code
Logo PIN code can be changed to your desired
Be sure to write down the new Logo PIN code and keep it at hand. If you lost the number, you could no longer change the Logo PIN code setting. For details on the PIN code setting, refer to the relevant instructions of the PIN code lock function on page 43.
39