Sanyo PLC-XP57L On start, Lamp control, Remote control, To change the code of the projector

SETTING

On start

When this function is “On,” the projector is automatically turned on just by connecting the AC power cord to an AC outlet.

NOTE:

•Be sure to turn the projector off properly (see “TURNING OFF THE PROJECTOR” on page 21). If the projector is turned off in the incorrect sequence, such as unplugging the AC power cord before completing the cool-down etc., the On start function does not operate properly.

Lamp control

This function allows you to change the brightness of the screen.

. . . . brightness according to the input signal.

. . . . normal brightness.

. . . . lower brightness reduces the lamp power consumption and extends the lamp life.

Remote control

The eight different remote control codes (Code 1–8) are assigned to this projector: the factory-set, initial code (Code 1) and the other seven codes (Code 2 to Code 8). This switching function prevents interference from other remote controls when several projectors or video equipment next to each other are operated at the same time.

For example, when operating the projector in “Code 7”, the code for both the projector and the remote control must be switched to “Code 7.”

To change the code of the projector:

Select from Code 1 to Code 8 in the SETTING Menu.

To change the code of the remote control:

Set the DIP switches 1–3 inside the battery compartment of the remote control. (See page 15.)

Remote control

When pressing the SELECT button at Remote control, the Remote control code menu appears.

41