Sanyo PLC-XP57L owner manual Projector is in cooling mode. It cannot be turned on until

APPENDIX

	Indicators
				Projector Condition
LAMP	WARNING	READY	LAMP
REPLACE	TEMP.	green	red
yellow	red
✽				The projector is in cooling mode. It cannot be turned on until
				the READY indicator lights green.
				The projector detects an abnormal condition and cannot be
				turned on. Unplug the AC power cord and plug it again to turn
				on the projector. If the projector is turned off again, disconnect
				the AC power cord and contact the dealer or the service
				center for service and checkup. Do not leave the projector on.
				It may cause electric shock or a fire hazard.
✽				The projector is in the Power management mode.
✽				The temperature inside the projector is abnormally high.
				The lamp cannot light up. (The projector is preparing for
				stand-by or the projection lamp is in cooling mode. The
				projector cannot be turned on until the cooling process is
				completed.)
				The lamp cannot light up. (The lamp has been cooled down
				enough and the projector is in stand-by mode and ready to be
				turned on with the POWER ON-OFF button.)
				The projection lamp reaches its end of life.
	✽			Replace the lamp and then reset the Lamp replacement
				counter. The indicator is turned off.
• • • on	• • • blinking		• • • dim	• • • off

*When the projection lamp reaches its end of life, the LAMP REPLACE indicator lights yellow. When this indicator lights yellow, replace the projection lamp with a new one promptly. Reset the Lamp replacement counter after replacing the lamp.

56