Operation
You should save changes to any of the following settings to a preset; otherwise they will be lost when a new input source or resolution is selected:
•Brightness
•Contrast
•Color saturation
•Tint
•Sharpness
•Gamma
•Lamp Settings
•Color temperature and white balance
To select a memory preset, press 
or 
to highlight it and press ENTER.
To save the settings for the current input and display mode to the Custom 1 or Custom 2 memory preset, select it, press 
or 
to highlight Save and press ENTER.
To save the settings for the current input and display mode to the
Note ISF Night or ISF Day memory preset, select Save ISF Night or Save ISF Day from the Calibration menu (refer to Save ISF Night/Save ISF Day on page 62).
To reset the Custom 1 or Custom 2 memory preset to its 
or 
to highlight Reset and press ENTER.
Signal / System: Select Information from the Main Menu, then choose either Signal or System to display information about the current input signal (resolution, frequency, type et cetera) and installed firmware versions, as well as other information that uniquely identifies your DHD Controller and display device.
Should you ever need to contact Runco Technical Support, this information will help them answer your questions or resolve product performance issues.
Signal |
|
Input Source | HDMI 1 |
Signal Format | 1080p/60 |
Input Resolution | 1920x1080 |
Vertical Freq | 59.94 Hz |
Horizontal Freq | 67.500 kHz |
Pixel Clock | 148.500 MHz |
Color Space | REC709 |
Sync Type | Separate |
Memory Preset | ISF Night |
|
|
System
Model | DHD3 |
Display Name | |
Output Resolution | 1920x1080 |
Serial Number | 00000000 |
Boot Version | 3.0 |
Firmware Version | 3.4 |
Micro Version | 3.3 |
|
|
Field Service / Manufacturing: The Field Service and Manufacturing menus are
Runco | 59 |