| Getting Started |
The Clock |
|
About the Clock | • Always set the clock after installation or after a power failure. Once power |
| returns to the oven, the clock defaults to 12:00 am. |
| • The time of day is displayed in hours and minutes. |
| • The clock time will appear during all oven operations except when the timer is |
| running. |
| • The oven is preset to a 12 hour clock and indicates AM and PM. To switch to |
| a 24 hour clock, see "Select Function” section. |
| • If you do not complete the operation of setting the clock, the oven will beep |
| periodically as a reminder to set the clock time. Press OFF to stop the beep- |
| ing. |
Setting the Clock | 1. CLOCK will be displayed and the hour digits | 12: |
| 00 AM |
|
|
| ||||
| will flash. Turn knob to select hour and AM or |
| CLOCK | ||
| PM. |
|
|
| |
|
|
|
|
|
2.Press Time. CLOCK will still be displayed and the minute digits will flash.
3.Turn knob. Set minutes.
4.Press Time and the clock is now set.
Note: If operation is not completed, the oven will beep periodically as a reminder to set clock time. Press OFF.
Changing the Clock
The Select Functions Menu
Change the Beep Vol- ume
1. | Press Time. TIMER 1 flashes in display. |
|
|
|
1 |
| Time | ||
2. | Turn knob to select CLOCK. |
| ||
|
| |||
3. | Press Time and hour digits flash. | 2 | Cooking Mode | |
4. | Turn knob to change hours. | Start | ||
|
| Temperature | ||
5. | Press Time again and minute digits flash. |
| ||
6.Turn knob to change minutes.
7.Press Time again and the clock is set.
Note: To cancel the TIME selection when setting the clock, press OFF at any time while in the clock mode.
SELECT FUNCTIONS is the section of the menu where you can set or change the range features listed below.
To access the SELECT FUNCTION menu
1.Press and hold COOKING MODE press pad for five (5) seconds. SELECT FUNCTION is displayed.
2.Turn knob slowly to desired feature. There will be a slight delay before each message (or feature) can be seen in the display. Turn knob slowly and wait approximately one second for display to show next feature.
3.Press START to choose the function.
4.Turn knob to desired setting and press START.
When all settings for the function are complete, SELECT FUNCTION flashes again.
5.Press OFF to exit the Select Functions Menu.
The volume of the control beep can be changed from LOW (softest) to HIGH (loudest). The control default for beep volume is Medium.
1.Access SELECT FUNCTIONS Menu.
2.Turn knob clockwise until VOLUME is displayed.
3.Press Start.
4.Turn knob to select volume level Low, Medium or High.
5.Press Start.
English 13